Advertisement
SPECIFICATIONS
Battery
Voltage
Pack
130247015
18 V
BPL-1820
18 V
BPL-1815
18 V
OPERATION
WARNING
Do not allow familiarity with products to make
you careless. Remember that a careless fraction
of a second is sufficient to inflict serious injury.
WARNING
Always wear safety goggles or safety glasses
with side shields when operating products.
Failure to do so could result in objects being
thrown into your eyes, resulting in possible
serious injury.
WARNING
Do not use any attachments or accessories
not recommended by the manufacturer of this
product. The use of attachments or accessories
not recommended can result in serious personal
injury.
APPLICATIONS
You may use this product for the following purposes:
n Charging and maintaining Ryobi One+ 18V battery
packs at peak charge every time (not over time).
CAUTION:
Charge in a well ventilated area. Do not block
charger vents. Keep them clear to allow proper
ventilation.
CAUTION:
If at any point during the charging process none
of the LEDs are lit, remove the battery pack from
the charger to avoid damaging the product. DO
NOT insert another battery. Return the charger
and battery to your nearest service center for
service or replacement.
Charger
Battery
Input
Capacity
220-240V,
1.7 Ah
50-60Hz,
AC only
220-240V,
2.4 Ah
50-60Hz,
AC only
220-240V,
1.4 Ah
50-60Hz,
AC only
English
BATTERY PROTECTION FEATURES
Ryobi One+ 18 V Lithium-Ion batteries are designed with
features that protect the Lithium-Ion cells and maximise
No. of
battery life.
cell for
battery
If the tool stops during use, release the trigger to reset
and resume operation. If the tool still does not work, the
15
battery needs to be recharged.
NOTE: The LED charge indicator light will not work if the
10
battery protection feature has caused the battery pack
to stop powering the tool. When the battery pack resets
itself, the LED will again function.
5
CHARGING THE BATTERY PACK
Use only Ryobi One+ 18V battery packs with
this charger.
Battery packs for this tool are shipped in a low charge
condition to prevent possible problems. Therefore,
you should charge them until the green LED on the front
of the charger comes on.
Note: The charger will also charge Ryobi One+ 18 V
Ni-Cd battery packs.
CHARGING A COOL BATTERY PACK
If the charger does not charge the battery pack under
normal circumstances, return both the battery pack and
charger to your nearest Authorised Service Center for
electrical check.
n Charge the battery pack only with the charger
provided.
n Make sure the power supply is normal household
voltage, 220-240V, 50-60Hz, AC only.
n Make sure the latches on each side of the battery
pack snap into place and the battery pack is secured
in the charger before beginning operation.
n Connect the charger to the power supply.
n Place the battery pack in the charger aligning the
raised rib on the battery pack with the groove in the
charger.
n Press down on the battery pack to be sure contacts
on the battery pack engage properly with contacts in
the charger.
Note: After charging is complete, the green LED will
remain on until the battery pack is removed from the
charger or charger is disconnected from the power supply.
n The battery pack will become slightly warm to the
touch while charging. This is normal and does not
indicate a problem.
2
Advertisement
