Shift to FM Mode
Press MODE repeatedly until < FM Radio > is showing up. For initial use, it will start at the beginning of
the FM frequency range (87.50MHz). Otherwise, the last listened FM station will be selected.
Note: or enter < Main menu >, and then turn SELECT to < FM >, press this knob to confirm
Scan Stations
Manual Scan
While frequency is showing up, press TUNE to activate 'turn to tune', and then turn SELECT to adjust
frequency 0.05MHz per step.
Automatic Scan
While frequency is showing up, press TUNE to activate 'turn to tune', then press SELECT to automatically
sacn
.
Note: the unit will display the frequency changing until it stops on the next station.
Scan Setting
By default, FM scans stop at any available station. This may result in a poor signal-to-noise ratio (hiss)
from weak stations.
To change the scan settings to stop only at stations with good signal strength, press MENU
< Scan setting > Strong stations only? Yes, press SELECT to confirm.
Audio Setting
By default, all stereo stations are reproduced in stereo. For weak stations, this may result in a poor
signal-to-noise ratio (hiss).
To play weak stations in mono, press MENU < Audio setting > Listen in mono only?
Yes, press SELECT to confirm.
s
Station Presets (for Internet, DAB and FM Mode)
Note: Your radio can store 10 Internet, 10 DAB+ and 10 FM stations preset. This order only limited to Internet,
DAB and FM mode.
To store the current station:
FM Mode
15
.