Sharp MD-ZV30 Operation Manual page 24

<P=002>
(Continued)
DISC-1
1
DISC-2
2
DISC-3
3
CD PLAY
ON/STAND-BY CD
VOLUME
3D SURROUND TUNER NAME / TIMER /
TRACK START
MODE ON/OFF (BAND) TOC EDIT DELETE DISPLAY
1 2 3
CD MD DIGITAL EDIT
1
MD/CD/TUNER DIRECT KEY
1 2 3 4 5
1
6 7 8 9 10/0
ST-MODE TUNER MD
10
BAND
1
P-MODE
PROGRAM CLEAR
REC AUTO
REC
3 MODE MARK
CD
1 2 3
1 2 3
3D SURROUND
SLEEP DISPLAY TIME
MODE ON/OFF
BASS/
ON/
AUX VOLUME
STAND-BY TREBLE
To record without using One-Touch
Editing
Without using one-touch recording, the following oper-
ation allows you to record from the first track.
1
Press the CD button.
2
Load a compact disc and a recordable MiniDisc.
3
Press the REC button.
The unit will enter the record stand-by mode.
4
Press the CD button.
0 6
To stop recording:
Press the MD button.
After the track number has been written on the Mini-
Disc, the recording will stop. However, CD playback
will continue.
Recording from the built-in radio onto a Mini-
Disc
2
1
Tune in to the desired station. (See pages 12 - 13.)
2
Load a recordable MiniDisc.
TUNING
CURSOR
MD
REC
ENTER
3
Press the REC
The unit will enter the record stand-by mode.
4 3
At this time, auto tuning is impossible.
Note:
Before recording an AM broadcast, enter the record standby
mode, and then separate the AM loop aerial from the main
unit. Adjust it so that the AM broadcast can be tuned in most
clearly.
4
4
Press the MD
During recording, you cannot change the station.
To stop recording:
Press the MD
After the track number has been written on the MiniDisc, the
recording will stop.
To interrupt recording:
Press the MD
Press the MD
number increases.
To record the track number during recording:
A recording is performed as a single track.
To identify different sections of the recording you can increase
the track number at any point during the recording process. To
create a new track number, whilst in the record mode, press the
REC button.
The track number will increase by one, and then the recording
will continue.
If you press the REC
a space of at least 15 seconds should be given between
tracks.
If the space is shorter than 15 seconds, tracks may not be
connected when they are edited.
To re-record
When you want to re-record, you can erase a track that is already
recorded, starting from any point in the old track, to begin a new
recording. Be aware that when you do this, all of the tracks and
track names that follow the newly recorded track will be erased.
1
During playback, press the MD
you want to begin re-recording.
The unit will pause.
2
Press the REC
"R. ERASE OK?" will be displayed.
3
Press the ENTER button.
This unit will be in the recording pause mode.
To cancel the operation, press the MD
4
Select the recording source and start recording.
E-22
MD-ZV30H TINSZ0217AWZZ
button.
button.
0 6
button.
button during recording.
0 6
button again to resume recording. The track
0 6
button and assign a track number,
button at the point where
0 6
button.
button.