Checking The Lower Unit For Air Leakage; Checking The Propeller - Yamaha F90D Service Manual

Outboard motor f90d
Hide thumbs Also See for F90D:
Table of Contents

Advertisement

CHK
ADJ
4. Insert a gear oil tube or gear oil pump
into the drain hole and slowly fill the gear
oil until oil flows out of the check hole and
no air bubbles are visible.
Recommended gear oil:
GEAR CASE LUBE
SAE: 90
Gear oil quantity:
3
670 cm
(22.7 US oz, 23.6 Imp oz)
5. Install the check screw and quickly install
the drain screw, and then tighten them to
the specified torque.
Gear oil check screw and drain
screw:
9 N·m (0.9 kgf·m, 6.6 ft·lb)
Checking the lower unit for air
leakage
1. Remove the check screw 1, and then
install the special service tool.
3-13
Periodic checks and adjustments
Pressure/vacuum tester:
YB-35956-A
2. Apply the specified pressure to check
that the pressure is maintained in the
lower unit for at least 10 seconds.
CAUTION:
Do not over pressurize the lower unit, oth-
erwise the oil seals can be damaged.
NOTE:
Cover the check hole with a rag when remov-
ing the tester from the lower unit.
Lower unit holding pressure:
100 kPa (1.0 kgf/cm
3. If pressure drops below specification,
check the drive shaft and propeller shaft
oil seals for damage.

Checking the propeller

1. Check the propeller blades and splines
for cracks, damage, or wear. Replace if
necessary.
2
, 14.5 psi)
6D81G11

Advertisement

Table of Contents
loading

This manual is also suitable for:

F90tr

Table of Contents