Manual Adjust; Manual Search - Sharp AQUOS LC-40LE924E Operation Manual

Basic adjustment

Manual adjust

E
Configure various settings for each service using the
colour (R/G/Y/B) buttons.
Service Service
no. name
Lock CH skip
1
Press a/b to select the desired service.
2
Press the colour button on the remote control
unit corresponding with the item you want to
reconfigure.
• The ✔ mark indicates the operation is set to on. Each
time the colour button is pressed, you can switch the
corresponding operation on/off.
Buttons for "Manual adjust" operation
Lock Press R button.
When the service is locked, you must enter your
PIN whenever you tune to the service.
CH skip Press G button.
Services with a ✔ mark are passed over when
pressing :r/s on the TV or remote control unit.
Delete Press Y button.
The selected service is deleted. If you want to
watch the service you deleted once again, perform
"Auto installation", "Additional search", or "Manual
search".
Sort Press B button.
The item position of services can be sorted.
Press a/b to select the service whose
1
item position you want to move, and then
press ;.
Press a/b to move it to the desired
2
position, and then press ;.
Repeat steps 1 and 2 until all desired
3
service items are sorted.
Cable
You can reconfigure the following settings when you
select "Cable" in the initial auto installation or the "Auto
installation" menu.
Additional search
E
Use this menu to add new services automatically after
"Digital search" in the "Auto installation" menu has been
completed. Follow steps 1 to 5 in Searching for
cable broadcasts on page 14.
Lock CH skip Old LCN
Delete Sort

Manual search

E
Add new services within a specified frequency band.
After setting the items on the following screen, the TV
starts searching.
• Refer to the table about menu items in the right column
on page 14.
Frequency
Symbol rate
QAM modulation
Search start
Manual adjust
E
This function is the same as in "Terrestrial". Refer to
"Manual adjust" in "Terrestrial".
H
• You can only reconfigure the "Manual adjust" settings.
• You can only set the "Lock" setting in "Manual adjust".
Satellite setting
Before selecting the type of search in "Satellite setting",
you need to select the satellite broadcast.
SAT2 [Hot Bird 13E]
SAT3 [None]
SAT4 [Turksat]
Additional search
E
Use this menu to add new services automatically after
auto installation has been completed. Follow steps 1 to 6
in the right column on page 15.
Manual search
E
Add new services within a specified frequency band.
After setting the items on the following screen, select
"Yes" from "Search start" menu.
Band [Vert/Low]
Frequency
Symbol rate
Search start
Manual adjust
E
This function is the same as in "Digital setting". Refer to
"Manual adjust" in "Digital setting".
MHz
Vert/Low
Vert/High
Horiz/Low
Horiz/High
35