Initial Auto Installation - Sharp AQUOS LC-40LE924E Operation Manual

Quick guide

Initial auto installation

When the TV is powered on for the first time after
purchase, the initial auto installation wizard appears.
Follow the menus and make the necessary settings one
after another.
Confirm the following before turning on
the power
E Is the antenna cable connected?
E Is the AC cord plugged in?
E Is the MAIN POWER switch turned on (;)?
1
Press <a on the TV.
• The initial auto installation wizard appears.
2
Setting the OSD language.
Press a/b/c/d to select the desired language,
and then press ;.
3
Selecting the location of the TV.
HOME
Press c/d to select where you will use this TV,
and then press ;.
• The confirmation screen pops up only when selecting
"STORE". Press c/d to select "Yes" or "No".
• HOME: "STANDARD" will be the default value for the "AV
mode" setting.
• STORE: "DYNAMIC (Fixed)" will be the default value for
the "AV mode" setting. If the "AV mode" is changed, the
TV will automatically switch back to "DYNAMIC (Fixed)"
when there is no signal input from the TV or remote
control unit for 30 minutes.
• STORE: A demonstration image will be displayed after
initial auto installation is completed. If you have chosen
"STORE" by mistake, go to "Setup" > "View setting" >
"Reset" > select "HOME" again.
4
Setting the country.
Press a/b/c/d to select your country or area,
and then press ;.
• This setting screen only appears during the first
installation.
NOTE
• If you set "Sweden" in the country setting, you can select
the cable provider "ComHem". Refer to the H mark
in the following steps or instructions about the settings for
"ComHem".
STORE
5
Starting channel search.
Digital search
Analogue search
Press a/b to select "Digital search", "Analogue
search" or "Skip", and then press ;.
• To watch both analogue broadcasts, digital broadcasts
and satellite broadcasts, you should perform the auto
installation setting for each format (Page 34).
• If you want to search for more broadcasts, execute
"Additional search" from the "Programme setup" menu
(Pages 34_36).
• When you select "Skip", only "Satellite search" will be
performed. You should perform "Digital search" and
"Analogue search" from "Auto installation" under the
"Setup" menu if needed.
• After performing "Digital search" or "Analogue search",
the screen swicthes to the "Satellite search" setting. You
should then execute "Yes" if you want to search for the
satellite channels.
NOTE
• If you turn off the power on the TV while performing a channel
search, the initial auto installation wizard will not appear. The
auto installation function allows you to execute the installation
again from "Setup" > "View setting" (Page 34).
• The initial auto installation wizard will abort if you leave the TV
unattended for 30 minutes before searching for channels.
• After initial auto installation is completed, the default PIN is
automatically set to "1234". To change the PIN setting, refer
to Password/Lock settings (Page 37). To clear the PIN setting
(PIN input will no longer be needed), refer to CLEARING THE
PIN (Page 59).
• When "Italy" is selected in the country setting, the default age
restriction value is set to 18.
Digital broadcast setting
Press c/d to select "Terrestrial" or "Cable",
and then press ;.
Terrestrial
H
• When you set "Sweden" in the country setting and select
"Cable" for the searching format, you can select the
cable provider "ComHem".
Searching for terrestrial broadcasts
E
The TV searches for, sorts and stores all the
receivable TV stations according to their
settings and the connected antenna.
• To abort the initial auto installation in progress, press 6.
After searching for DVB-T channels, the
screen switches to the "Satellite search"
setting (Page 15).
Skip
Cable
13