Siemens Gigaset E360 User Manual page 7

First steps
Attaching the belt clip
There are notches for attaching the belt clip
on the side of the handset at the same
height as the display.
¤
Press the belt clip onto the back of the
handset so that the protrusions on the
belt clip engage with the notches.
You can also attach a cord for carrying the
handset in your hand or wearing it around
your neck.
Opening the battery cover
¤
If fitted, remove the belt clip.
¤
Reach into the housing cavity and pull
the battery cover upwards.
6
Placing the handset in the base
station and registering
the handset must not already
Requirement:
be registered on base station.
any
Registering the handset on the Gigaset E360
base station occurs automatically.
¤
Place the handset in the charging cradle
of the base station with its
.
forward
You will hear a confirmation tone.
Automatic registration can take up to
5 minutes. While registration is in progress
the screen displays Registering . The hand-
set is assigned the lowest unassigned inter-
nal number (1–4). If several handsets are reg-
istered on the base, the internal number is
shown in the display after registration, for
example 2. This means that the handset has
been assigned the internal number 2.
Notes:
– Automatic registration is only possible if the
base station on which you wish to register the
handset is not being used to make a call.
– A key press cancels automatic registration.
– If four handsets are already registered on the
base station there are two options:
– The handset with the internal number 4 is
in idle status: the handset you wish to reg-
ister is assigned the number 4. The hand-
set that was previously number 4 is de-
registered.
– The handset with the internal number 4 is
being used: the handset you wish to regis-
ter cannot be registered.
– If automatic registration does not work the
handset will have to be registered manually
(page 17).
¤
To charge the batteries, leave the handset
in the charging cradle on the
base station.
Notes:
– The handset may only be placed in the base/
charging cradle provided for it.
– If the handset has switched itself off because
the batteries are flat and is then placed in the
base/cradle, it will switch itself on automati-
cally.
display facing