Siemens Gigaset S670 User Manual page 12

The polarity is indicated in/on the battery
compartment.
Closing the battery cover
¤
First, align the notches on the side of
the battery cover with the protrusions
on the inside of the housing.
¤
Then press the cover until it clicks into
place.
Attaching the belt clip
There are notches for attaching the belt
clip on the side of the handset at the same
height as the display.
¤
Press the belt clip onto the back of the
handset so that the protrusions on the
belt clip engage with the notches.
Opening the battery cover
¤
If fitted, remove the belt clip.
¤
Place your fingertip in the cavity in the
casing and lift the battery cover
upwards.
Placing the handset in the base station
and registering
¤
Place the handset in the base station
with its display facing upwards.
The handset registers automatically. Reg-
istration can take up to 5 minutes. During
this time Regstr.Procedure
display and the name of the base station
flashes, e.g. 1. The handset will be
Base
assigned the lowest unassigned internal
number (1–6).
This will appear in the display when regis-
tration is complete, e.g.
that the number 1 has been assigned. If
the internal numbers 1–6 are already
assigned to other devices, the number 6 is
overwritten.
Please note:
– Automatic registration is only possible
while no one is making calls using the base
station.
– Each key press interrupts the automatic
registration.
– If automatic registration does not work the
handset will have to be registered manually
(page 42).
– You can change the name of the handset
(page 45).
To charge the batteries, leave the handset
in the base station.
First steps
appears in the
1. This means
INT
9