Installing Components - Harman Kardon Car Stereo System Owner's Manual

Installing Components

Installing the Electronics Enclosure
At the selected site, install the Electronics Enclosure. Use either the
enclosed cable ties or mounting screws, as shown below.
Installing the Text Display
1. Temporarily place the Text Display at the proposed site
and check the default viewing angle while adjusting the
pivot arm. If it meets your needs, then skip to step 2.
Otherwise, change the viewing angle as follows:
a. Using the 3mm hex key, loosen the recessed hex screw
(inside the display base) until the pivot arm is free from
the display assembly. The hex screw will remain captive.
Recessed
Hex Screw
6 INSTALLATION
b. Select another viewing angle position (middle or top).
Reassemble the parts in reverse order and tighten the
recessed hex screw.
3mm
Hex Key
2. At the base, using the 1.5mm hex key, loosen (but do not
remove) the hex setscrew.
3. To install the Text Display with adhesive tape, perform the
following steps or skip to step 4:
a. Insert the mounting plate, rotate it 180°, and tighten
the hex setscrew as shown below.
Hex Setscrew
Display
Base
Display
Assembly
Mounting
Plate
Adhesive
Pad