Wireless Centre Part Names; Setting Up The Wireless Centre - Sharp AQUOS LC-15L1E Operation Manual

Wireless Centre Part Names

Main unit
Front
SIGNAL LEVEL
Power Power indicator
button · Green:
Operation in
progress
(when power is on)
· Red: Standby
Placing the Wireless Centre Where You Want It
We recommend placing the Wireless Centre in an area
where there are no obstructions to impede radio wave
transmission/reception.
(Do not place the Wireless Centre in a box.)

Setting Up the Wireless Centre

• The Wireless Centre can be placed horizontally or upright.
• When placing horizontally:
The side on which the rubber feet are attached is the
bottom.
Rubber foot
Wireless Centre
Transmission
Antenna
input
terminal
SIGNAL LEVEL
indicator
(Reception gain)
· Green:
Communication
Antenna
in progress
output
· Red:
terminal
Difficulty
AV-IN1 (RGB)
in transmission
(21-pin Euro-SCART)
· Not lit:
Not communicating
• When placing upright:
Fasten the stand to the bottom of the Wireless Centre with
the screws provided.
Rubber foot
* Failure to securely fasten the stand may cause the Wireless
Centre to tip over during use.
* When placing the Wireless Centre upright, make sure to use
the SCART to SCART flat cable (commercially available) for
a connection. The use of this cable can prevent the Wireless
Centre from falling down (See page 44).
Power Indicator
When the TV is turned off with the remote control, the
Wireless Centre is switched to standby (power indicator
is lit red). (There may be a time lag of about 5 to 6
seconds.)
Rear
AV-IN2 (AV)
(21-pin AV-SCART)
IN
AV-IN2 ( AV )
L
R
OUT
AV-IN1 ( RGB )
AUDIO (L)
AUDIO (R)
AV-IN3
VIDEO
S-VIDEO
Wireless Centre
stand
Factory
adjustment
terminal
AV-IN3
VIDEO
AUDIO
AV-IN3 IR POWER FACTORY
MOUSE INPUT SETTING
DC12V
S-VIDEO
Power input
DC 12V
Video control
terminal
13