Maintenance - Hunter 94035 Owner's Manual

MAINTENANCE

This fan is permanently lubricated and
will not require additional lubrication
(oil) for the life of the fan. This fan
requires little maintenance and
contains no user serviceable parts.
DO NOT try to fix it yourself. Contact
qualified service personnel if servicing
is needed.
TO CLEAN:
1. Before cleaning, turn fan off and
unplug from electrical outlet.
Wipe off excess dust with a
lintfree cloth.
2. To ensure adequate air
circulation to the motor, keep
vents located at the rear of the
motor housing free from dust
accumulation. A vacuum cleaner
hose can be used to clean these
vents.
3. DO NOT immerse the fan in
water or any other liquid.
CLEANING GRILL AND BLADE:
1. Turn the fan off and unplug from
the electrical outlet.
2. Remove the Front Grill by
carefully removing the Ring
Screw at the bottom of the Ring.
See Figure 4.
3. Remove the Lower Decorative
Piece. See Figure 4.
4. Remove the Ring. See Figure 4.
5. Insert a flat-head screwdriver
between the grill wires at the top
of the grill, between the Upper
Grill Tabs. See Figure 4. Pry the
Front Grill away from the Back
Grill.
6. Grills and blades may be cleaned
with mild soap and water.
6
7. Use a soft, slightly damp cloth to
wipe the remaining fan parts.
8. DO NOT allow water or any
other liquid to get into the motor
housing or base.
9. After the Blades and Grills have
completely dried, reposition
the Front Grill to the Back Grill
while ensuring the Hunter logo is
straight.
10. Place the Lower Grill Tab into
position at the bottom of the Back
Grill and over the Back Grill wire.
Then snap the Upper Grill Tabs
into position under the Back Grill
wire.
11. Replace the Ring while ensuring
the Ring Screw is at the bottom
of the Grill. Then, tighten the
Ring Screw 10 - 20 turns.
12. Replace the Lower Decorative
Piece while ensuring it is
centered on the Front Grill. Then,
tighten the Ring Screw.
13. DO NOT plug fan into an
electrical outlet until it has been
fully reassembled.
Upper Grill Ring
Front Grill
Tabs
Lower Decorative
Lower Grill
Piece
Tab
FIGURE 4
Blades Back Grill
Ring Back Grill
Screw Wire
44244-01 03/19/2009