Installation - Panasonic CQ-RD132N Operating Instructions Manual

Installation

E
N
G
L
I
Preparation
S
H
¡Before installation, check the radio operation with antenna and
13
speakers.
¡Disconnect the cable from the negative (–) battery terminal
(see caution below).
¡Unit should be installed in a horizontal position with the front
end up at a convenient angle, but not more than 30°.
30° or less
Caution: Do not disconnect the battery terminals of a car
with trip or navigational computer since all user settings
stored in memory will be lost. Instead take extra care with
installing the unit to prevent shorts.
Dashboard Installation
Installation Opening
The unit can be installed in
any dashboard having an
opening as shown at right.
The dashboard should be
4.5 mm - 6 mm thick in order to be able to support the unit.
Installation Precautions
This product should be installed by a professional installer, if pos-
sible.
In case of difficulty, please consult your nearest authorized
Panasonic Service Center.
1. This system is to be used only in a 12-volt, DC battery system
(car) with negative ground.
2. Follow the electrical connections carefully
Failure to do so may result in damage to the unit.
3. Connect the power lead (red) after all other connections are
made.
4. Be sure to connect the battery lead (yellow) to the positive ter-
minal (+) of the battery or fuse block (BAT) terminal.
5. Insulate all exposed wires to prevent short circuiting.
6. Secure all loose wires after installing the unit.
7. Please carefully read the operating and installation instructions
of the respective equipment before connecting it to this unit.
18
CQ-RD152/RD142/RD132N
53 mm
182 mm
(a Page 22).
¡We strongly recommend that you wear gloves
for installation work to protect yourself from
injuries.
First complete the electrical connections, and then
check them for correctness.(a
Lock Lever (C)
Power Connector y
Make sure that the lock
lever (C) is flush with
the mounting collar (not
projecting outward).
Page 22)
Lock Lever