Cassette Tape Player Basics - Panasonic CQ-RD132N Operating Instructions Manual

Cassette Tape Player Basics

E
N
G
L
I Mode Selection
S
H
You can switch to the cassette player mode as shown below.
9
CD Changer Mode
From:
Radio Mode
Note: You can not select CD Changer mode or Radio mode while tape playing.
If you want to select CD Changer mode or Radio mode, eject the tape.
Tape Insert and Playback
Insert a cassette tape. Playback will start automatically.
Stop and Tape Eject
Press [u] to stop tape play and eject the cassette tape.
The unit will be automatically switched back to radio mode.
Notes on Cassette Tape
Tape Slack:
Use a pencil or similar object to take up the
slack as shown. If a loose tape is used, this
may result in the tape becoming tangled in
the rotating parts of the unit.
Notes:
¡To maintain your cassette player in top condition, avoid using tapes that are longer than 90 minutes (C-90).
¡If you insert into the unit a cassette with a loose tape caused by forcing it into cassette with a finger or the like, the cas-
sette may not be properly reproduced. In such a case, eject the cassette, make the tape tight, then insert it back into the
deck.
¡Always remove the cassette when you stop using the cassette player. This will prolong the life of your tape.
14
CQ-RD152/RD142/RD132N
Insert a cassette tape.
Eject
CQ-RD152N
APM
SCAN
1 2
MUTE
Pencil
Do not touch or
pull out the tape.
PRG
CASSETTE RECEIVER
PWR
EON PTY CT
E E
REPEAT
3 4 5 PTY
DISP
Exposed end
(Open end)
Exposed end
(Open end)