Aiwa XR-EM50 Operating Instructions Manual page 14

s
wREC/
En
REC PAUSE
Edited CD recording
AI Edit Recording
Preparation
Prepare a tape that is longer than the CD length.
When recording a whole CD, AI Edit Recording takes the length
of your tape into account and rearranges the recording order of
the tracks if necessary, so that no track is cut short at the end
of the side.
(AI: Artificial Intelligence)
• Recording cannot start from a point halfway in the tape.
• AI Edit Recording cannot be used with discs containing more
than 30 tracks.
1 Insert the recording tape.
2 Press FUNCTION on the remote control to select
the CD function, and load the disc.
3 Hold down SHIFT and press CD EDIT/CHECK on
the remote control in stop mode.
"AI EDIT" and "AI C--00" is displayed.
14
CD EDIT/
CHECK
REC/
REC PAUSE
f,g
SHIFT
4 Press the numbered buttons on the remote
control to enter the length of the recording tape.
10 to 99 minutes can be specified.
- For a 60-minute tape press 6 and 0.
In a few seconds, the unit determines the tracks to be
recorded for each side.
•f or g can also be used to specify tape length.
5 Press wREC/REC PAUSE once to start recording.
The tape is rewound to the beginning of the side facing
out from the unit, "REC MUTE" flashes on the display
and the lead segment is played through for 10 seconds,
and recording starts.
When recording on the side facing out from the unit (side
A) finishes, recording on the opposite side (side B) starts.
On the remote control, hold down SHIFT and press REC/
REC PAUSE to start recording.
Programmed Edit Recording
As you program the CD tracks to record, Programmed Edit
FUNCTION
Recording displays the remaining recording time for each side
of the tape, so you can easily select a set of desired tracks
0–10, +10
within the length of your tape.
• Recording cannot start from a point halfway in the tape.
• You cannot program more than 30 tracks.
s
• You cannot program a track with a track number larger than
f,g 30.
1 Insert the recording tape.
2 Press FUNCTION on the remote control to select
the CD function, and load the disc.
3 Hold down SHIFT and press CD EDIT/CHECK
twice on the remote control in stop mode.
"PRGM EDIT" and "PRGM C--00" is displayed.
4 Press the numbered buttons on the remote
control to enter the length of the recording tape.
10 to 99 minutes can be specified.
- For a 60-minute tape press 6 and 0.
•f or g can also be used to specify tape length.
5 Press the numbered buttons on the remote
control to select the first track to be recorded on
side A.
-To select the 25th track, press +10, +10 and 5.
-To select the 11th track, press +10 and 1.