Chicago Electric 95136 Set Up And Operating Instructions Manual page 7

13. never use oil or grease on any inlet
connector, outlet connector, or
cylinder valves.
14. use only supplied torch on this
Inverter Air Plasma Cutter. Using
components from other systems may
cause personal injury and damage
components within.
15. This product, when used for cutting
and similar applications, contains or
produces a chemical known to the State
of California to cause cancer and birth
defects (or other reproductive harm).
(California Health & Safety Code §
25249.5, et seq.)
16. People with pacemakers should consult
their physician(s) before using this
product. Electromagnetic fields in close
proximity to a heart pacemaker could
cause interference to, or failure of the
pacemaker.
17. USE PROPER EXTENSION CORD.
Make sure your extension cord is in good
condition. When using an extension cord,
be sure to use one heavy enough to
carry the current your product will draw.
An undersized cord will cause a drop in
line voltage resulting in loss of power
and overheating. A 50 foot extension
cord must be at least 12 gauge in
diameter, and an 100 foot extension cord
must be at least 10 gauge in diameter.
If in doubt, use the next heavier gauge.
The smaller the gauge number, the
heavier the cord.
18. This product requires a 3-prong, 240
V~, twist-lock plug (not included). This
plug must be installed by a qualified
electrician.
rev 09j
SKU 95136 For technical questions, please call 1-800-444-3353.
symbology
Double Insulated
Canadian Standards Association
Underwriters Laboratories, Inc.
v~
Volts Alternating Current
A
Amperes
No Load Revolutions per Minute
n 0 xxxx/min.
(RPM)
Page 7