Parts, Tools, Materials - Bosch HMV9302 Installation Instructions Manual

THE FOLLOWING PARTS ARE SUPPLIED WITH THE OVEN:
NOTE: Depending on your ventilation requirements, you may not use all of these parts.
Damper/duct connector
(for roof vented or wall vented installation)
Not Actual Size
One power cord clamp bushing -
Four 1/4" x 2" lag screws - Actual Size
(for wall stud holes)
Two 1/4" x 3" bolts - Actual Size
(for securing to the upper cabinet)
OR
Four spring toggle heads - Actual Size
(for the toggle bolts)
NOTE: You need to install at least one lag screw into a 2" x 4" stud and four anchor bolts into the wall,
and the mounting area must meet the 150 lbs. weight requirement.

PARTS, TOOLS, MATERIALS

Actual Size (for the cord hole in a metal upper cabinet)
5
One power cord clamp and
One dark-colored mounting screw
(to hold the power cord)
Actual Size
Four 1/4" x 3" toggle bolts - Actual Size
(for drywall holes)
Two tapping screws - Actual Size
(for attaching the damper duct connector)
One upper cabinet template - Not Actual
Size
centerline
10-
8"
Upper-cabinet template
Roof-venting installation
B
C D
12"
6"
11
10- 3
16
8-
4"