Chevrolet Corvette 2012 Manual page 70

3. Load the map DVD into the DVD
slot by inserting it partway. The
system pulls it in.
4. Wait until the DVD is loaded
properly and then press the
button to close the faceplate.
Once the map DVD is inserted
correctly, the system displays the
Caution screen.
Press to proceed to the
navigation system.
The map appears showing your
current vehicle position.
If an error displays and/or the map
disc comes out, it could be for one
of the following reasons:
If the map disc was installed into
the CD slot. See Installing the
DVD Map Disc previously.
It is very hot, when the
temperature returns to normal,
the map disc should play.
You are driving on a very rough
road. When the road becomes
smoother, the map disc
should play.
The map disc is dirty, scratched,
wet, or upside down.
If any error occurs repeatedly or if
an error cannot be corrected,
contact your dealer.
When the DVD map disc is not
loaded, you are not able to use the
navigation portion of the system.
1. Turn the ignition on.
2. Press the (Open/Close
Faceplate) button and the
faceplate opens.
3. Press DVD, located next to
the bottom slot. The disc ejects.
4. Wait until the DVD is ejected
properly and then press
(Open/Close Faceplate) to close
the faceplate.
When handling the DVD map disc,
be careful of the following:
Handle the disc very carefully to
avoid contamination or flaws.
Signals may not read out
properly if the disc gets
contaminated or flawed.
If the disc gets soiled, use a soft
cloth to gently wipe it out from
the center of the disc to the
outside. Do not use
photographic record cleaner,
solvents, or other cleaners.
Do not use the disc to rest on
while writing or drawing using
any writing utensil or attach a
seal to any of the sides or
the disc.
Do not keep the disc in direct
sunlight, high temperatures,
or humidity.
After using the disc, place it
back into the original case.