Vector MAXX SST 1000 VEC049 Owner's Manual
  1. Manuals
  2. Brands
  3. Vector Manuals
  4. Inverter
  5. MAXX SST 1000 VEC049
  6. Owner's manual

Vector MAXX SST 1000 VEC049 Owner's Manual

1000 watt continuous / 2000 watt peak converts 12 volt dc to 110 volt ac advanced mosfet technology
Hide thumbs
Table of Contents

Advertisement

Quick Links

Enlarged version
VEC049
MAXX SST
1000
TM
POWER INVERTER
1000 WATT CONTINUOUS / 2000 WATT PEAK
CONVERTS 12 VOLT DC TO 110 VOLT AC
FRONT
ADVANCED
MOSFET
TECHNOLOGY
OWNER'S MANUAL
THIS MANUAL CONTAINS IMPORTANT INFORMATION REGARDING SAFETY, OPERATION,
MAINTENANCE AND STORAGE OF THIS PRODUCT. TO AVOID POSSIBLE INJURY OR PROPERTY
DAMAGE, PLEASE READ THIS INSTRUCTION MANUAL CAREFULLY BEFORE USING THIS PRODUCT.
© 2002 VECTOR MANUFACTURING, Ltd.
4140 S.W. 28TH WAY • FT. LAUDERDALE, FL 33312
4140 S.W. 28TH WAY • FT. LAUDERDALE, FL 33312
TEL 954.584.4446 • FAX 954.584.5556
TOLL-FREE: (866) 584-5504
REV.110802

Advertisement

Table of Contents
loading

Related Manuals for Vector MAXX SST 1000 VEC049

Summary of Contents for Vector MAXX SST 1000 VEC049

  • Page 1 MAINTENANCE AND STORAGE OF THIS PRODUCT. TO AVOID POSSIBLE INJURY OR PROPERTY DAMAGE, PLEASE READ THIS INSTRUCTION MANUAL CAREFULLY BEFORE USING THIS PRODUCT. © 2002 VECTOR MANUFACTURING, Ltd. 4140 S.W. 28TH WAY • FT. LAUDERDALE, FL 33312 4140 S.W. 28TH WAY • FT. LAUDERDALE, FL 33312 TEL 954.584.4446 •...
  • Page 2 IMPORTANT SAFETY INFORMATION To ensure reliable service, your power inverter must be installed and used properly. Please read the installation and operating instructions thoroughly prior to installation and use. Pay particular attention to the WARNING and CAUTION statements in this manual. The CAUTION statements advise against certain conditions and practices that may result in damage to your inverter.

  • Page 3: Table Of Contents

    WARRANTY ACTIVATION: Please complete Warranty Activation Card and mail to Vector Manufacturing. Enter “VEC049” as Model and Power 5.5 Permanent Installation ......16 Inverter as “Product Type”.

  • Page 4: Introduction

    INTRODUCTION MAINTENANCE Your new Vector MAXX SST 1000 inverter is one in a series of the most The inverters require minimal maintenance. However, for optimum perform- advanced DC to AC inverters available. With proper care and appro- ance, perform the following as required.

  • Page 5: Front Panel

    8.2 TROUBLESHOOTING GUIDE FIGURE 1 – FRONT PANEL TROUBLE/ INDICATION POSSIBLE CAUSE SUGGESTED REMEDY No AC output – DC input below 10 Volts Recharge or replace red LED lit battery No AC output – Excessive appliance Reduce load-wait for red LED lit load-thermal shutdown inverter to cool.

  • Page 6: Maxx Sst 1000 Safety Features

    1.2 MAXX SST 1000 SAFETY FEATURES 8.0 TROUBLESHOOTING BUILT-IN SAFETY FEATURES INCLUDE: • Automatic overload and over-temperature shutdown activated 8.1 COMMON PROBLEMS: if AC output exceeds 1000 watts. • Automatic AC short-circuit shutdown and automatic reset POWER TOOLS AND MICROWAVE OVENS WON’T START •...

  • Page 7: Appliance Cautions

    Not all fluorescent lamps operate properly with this type of inverter. If the bulb 23. If steps 21 and 22 do not correct the problem, contact Vector appears to be too bright, or fails to light, do not use the lamp with this inverter.

  • Page 8: Inverter Applications

    2.0 INVERTER APPLICATIONS This procedure is for using locally purchased supplies. Make appropriate changes to procedure if Vector Cable Set is Aside from issues of supplying power to higher wattage appliances, purchased . inverters must be supplied with a constant source of high current12 volt DC from a bank of batteries.

  • Page 9: Theory Of Operation

    If inverter is to be installed in a moving vehicle, Vector strongly recommends that the inverter be shock-mounted either on the floor (in a 3.0 THEORY OF OPERATION...
  • Page 10 A. Check all connections and tighten any loose connections. B. Ensure that the source battery has adequate charge. C. If steps A through B do not correct the problem, contact Vector Customer Service Department (954) 584-4446 ext. 119 for professional direction.

  • Page 11: Operation

    CAUTIONS: 4.0 OPERATION NOTE: Ensure that the total continuous power consumption of all tools This device supplies 110 VAC electrical power directly to the appliances through three standard, North American U-ground receptacles. NEVER try and/or appliances connected to the inverter (and in use) does not exceed to use the inverters with any 12-VDC-power source that uses a positive 1000 watts.
  • Page 12 1020 approved for marine use) rated #4 AWG. For cable lengths exceeding 4 feet from inverter to batteries, call Vector Manufacturing for additional installation information. The cable, fuse holder, fuse (not supplied) can be NOTE: APPLIANCE SPECIFICATIONS MAY VARY FROM BRAND TO purchased at an electrical supply company.

  • Page 13: Determining Battery Size

    100 watts. Typical use of a microwave is only for a few minutes, sometimes cables are measured for installing the inverter. Available through Vector at low power. Some exceptions to brief operating times are lamps, TVs and Technical Support at (954) 584-4446 Ext. 119.

  • Page 14: Battery Operating Time

    OFF then ON does not reset the inverter, DO NOT ATTEMPT TO OPEN THE INVERTER. Opening the inverter, for any reason, will void the warranty. The unit must be returned to Vector Manufacturing, Ltd. for testing and repair by professional factory technicians.

This manual is also suitable for:

Maxx sst 1000Vec049

Table of Contents