Whitfield Profile 20 FS Installation And Operation Manual page 30

SPECIFICATIONS - PROFILE
Cat. No. H0368 Model Profi le 30 FS-2
Flue Size
Width, Overall
Depth, Overall
Depth, Overall w / 3" tee
Height
Floor to Rear
Flue Center
Facing Back of Unit,
outside edge on right
to center of rear
fl ue outlet
Floor to Rear
Outside Air Inlet
Facing Back of Unit
outside edge on left
to center of air inlet
Floor Protection
Requirements
Standard Features
Hopper Capacity
Burn time
Fuse, Control Board
Fuse, Igniter
Heat Input (Max.)
Overall Effi ciency
Emissions
Ship Weight
Room Air Blower
2175 rpm
Exhaust Blower
3000 rpm
Auger Motor
Options
30
30 FS-2
®
Pellet Stove
3" (76 mm) Rear
25-7/8" (657 mm)
24-7/8" (632 mm)
30-3/4" (781 mm)
31-3/8" (797 mm)
16-7/8" (429 mm)
5-1/8" (129 mm)
10" (254 mm)
13" (330 mm)
Front and Side: 6" (152 mm)
Back: 1" (25 mm)
Fastfi re™ Self Igniter
Wall Thermostat
(wire included)
70 bs.
16 - 41 hours
5 Amp, 250 volt, 3AG
6 Amp, 125 volt
14,000 - 38,000 BTU / hr
81%
1.9 gr / hr (varies
w / size and type of fuel)
EPA exempt
270 lbs.
150 CFM; .8 Amps,
95 CFM: 1.0 Amps,
1.1 RPM; .4 Amps
Nickel or Gold Trim Kits
4" Quick Disconnect
Log Set
NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE
8-7/8"
10"
13"
BACK VIEW
24-7/8"
SIDE VIEW
Note: Dimensions shown are approximations only (+/- 1/4")
Non-combustible fl oor protection must be used when installed on carpet
(see Floor Protection, Page 5).
Fuel delivery and burn times will vary depending on size and type of fuel
used. Estimated heat input based on fuel value of 8400 BTU per lb.
Fuses are rated as fast blow.
25-7/8"
31-3/8"
16-7/8"
5-1/8"
30-3/4"