Panasonic PV-D4753SK Operating Instructions Manual page 55

*Important: If a remote control button does not work when pressed,
press the DVD button on the remote and try the button again.
Speaker Output Setup
Set the number of speakers connected to the receiver
(amplifier, decoder.) (See pp.14, 15.)
1
Do steps 1~3 on page 54.
2
AUDIO OUTPUT
LPCM(DVD) : OFF
D o l b y D i g i t a l : B i t s t r e a m
d t s : B i t s t r e a m
DRC : OFF
SPEAKER SETUP SPEAKER SETUP
SELECT :
SET : SET
END : ACTION
3
SPEAKER SETUP
SPEAKER OUTPUT : MULTI-CHANNEL SPEAKER OUTPUT : MULTI-CHANNEL
SPEAKER SIZE
OUTPUT BALANCE
DELAY TIME
SELECT :
SET : SET
END : ACTION
I I I I I SPEAKER OUTPUT
MULTI-CHANNEL: (Factory preset)
Use this setting when 3 or more speakers are
connected. In this case, it is necessary to set
[SPEAKER SIZE], [OUTPUT BALANCE], and
[DELAY TIME].
2-CHANNEL:
When 2 speakers are connected, it is not
necessary to set [SPEAKER SIZE], [OUTPUT
BALANCE], and [DELAY TIME] (these setting
menu are not displayed.)
4
Press ACTION three times to exit.
Speaker Size Setup
Speaker frequency properties and the existence of speakers is set.
1
Do steps 1~2 of "Speaker Output Setup" above.
2
SPEAKER SIZE
FRONT FRONT : LARGE : LARGE
CENTER : LARGE
SURROUND : LARGE
SUBWOOFER : ON
SELECT :
SET : SET
END : ACTION
Menu item Setting
LARGE(factory preset)
FRONT
SMALL
LARGE(factory preset)
CENTER
SMALL
NONE
LARGE(factory preset)
SMALL
SURROUND
NONE
ON(factory preset)
SUBWOOFER
OFF
3
Press ACTION four times to exit.
4753S-K(E) P36-60 (030225) RAM.p65
Press
to select "SPEAKER
SETUP," and
press SET to display
SPEAKER SETUP
screen.
Press
to select "SPEAKER
OUTPUT,"
and
press SET repeatedly.
(See below.)
Press
to select "SPEAKER SIZE," and press SET
to display SPEAKER SIZE screen.
Press
to select an item, and press SET
repeatedly. (See below table.)
Remark
When the front speakers (R/L) supports low-frequency (under 100 Hz) reproduction.
Select when the front speakers (R/L) does not support low-frequency reproduction.
When the center speaker supports low-frequency (under 100 Hz) reproduction.
Select when the center speaker does not support low-frequency reproduction.
If there is no center speaker.
When the surround speakers (R/L) supports low-frequency (under 100 Hz) reproduction.
Select when the surround speakers (R/L) does not support low-frequency reproduction.
If there is no surround speaker.
If there is a subwoofer.
If there is no subwoofer speaker.
** If SUBWOOFER is set to "OFF,"
the front speakers are set to
"LARGE" automatically.
55
ACTION
SELECT
SET
55
2003/03/25, 13:21