Yamaha EXCITER 270 Owner's Manual page 66

3) Wash down the hull, helm, and both
jet drive units with fresh water.
4) Remove hull drain plug and the two
engine compartment drain plugs.
Rinse the engine compartment with
a small amount of fresh water. Be
careful not to get water on the car-
buretor or electrical components.
Allow any water in the bilge to drain
out. After the water has drained,
wipe the engine compartment and
bilge with dry rags. Reinstall all
drain plugs.
_________________
NOTE:
This boat is equipped with an electric
bilge pump that automatically removes
excess water from the bilge while you
are underway. However, some residual
water remains that must be drained by
removing the drain plug.
CAUTION:
Tighten the hull drain plug securely
before launching the Jet Boat. Clean
any foreign material, such as dirt or
sand, from the threads before
installing the drain plug.
5) Spray a rust inhibitor, such as
Yamaha Silicone Protectant and
Lubricant, on metallic parts to mini-
mize corrosion.
3-21
O
PERATION
___________
3