Sony FD Trinitron Wega KV-27FV310 Operating Instructions Manual page 18
Hide thumbs
Also See for FD Trinitron Wega KV-27FV310:
- Service manual (268 pages) ,
- Operating instructions manual (68 pages) ,
- Specifications (1 page)
Table of Contents
Advertisement
Connecting Your TV
Cable Box and Cable
Use this connection
if you subscribe
to a cable system that scrambles
some channels (pay
channels)
but not all of them. This setup allows you to use the remote control to:
change channels
through
your cable box when you are receiving
a scrambled
signal
n
change channels
through your TV
This connection also allows you to use the PIP feature when you are viewing unscrambled
channels coming directly into your TV from your cable. Scrambled
signals coming through the
cable box cannot be viewed in PIP. For more information
on the PIP feature, see page 26.
Cable box
Coaxial cable
2
75-ohm Coaxial cable
1
CAW cable
(unscrambled
channels)
Rear of W
1
Connect the coaxial cable from your cable service to the VHF/UHF
jack on your TV.
2
Using a coaxial cable (not supplied), connect the IN jack on your cable box to the TO
CONVERTER jack on your TV.
3
Using a coaxial cable (not supplied), connect the OUT jack on your cable box to the AUX
jack on your TV.
Using your W with this connection
This connection allows you to do the following:
Q
Program your Sony remote control to operate your cable box (see page 5).
lULT_BUE
n
To activate your remote, press
CUD to operate your cable box and then use the 0-9
buttons or CH+/- buttons to change the channels. To do this, first program your remote
control, then use the Channel Fix feature to set your TV to channel 3 or 4 (see page 33).
Press (Z_ to switch back and forth between VHF/UHF
(local channels or unscrambled)
and AUX (cable system or pay channels).
13
Advertisement
Table of Contents
