Sony KV-36FV300 Operating Instructions Manual page 58

Problem Possible Solutions
Cable stations _
Make sure Cable is set to On in the Channel Setup menu
don't seem to work (page 37).
Perform Auto Program to add channels that are not presently in
the memory (page 21).
Remote control ru
Press TV (FUNCTION) when operating your TV.
does not operate _ Check the orientation of the batteries.
Batteries could be weak. Replace them (page 2).
Move the TV three to four feet away from fluorescent lights.
Cannot change ru Make sure you have not inadvertently switched your TV from the
channels with the channel 3 or 4 setting if you are using another device to change
remote control channels.
If you are using another device to control channels, be sure that
you have pressed the FUNCTION button for that device. For
example, if you're using your VCR to control channels, be sure to
press the VCR/DVD FUNCTION buttons (page 3 for remote
Y181, page 5 for remote Y182).
Cannot access ru If you use the _u button to close the Basic menu, only the Basic
other menus when menu appears when you press _u again. To access the other
using the Basic menus, select the Advanced Menu option (page 47).
menu
The remote control ru
Press the TV FUNCTION button. You may have inadvertently
doesn't work in PIP
pressed the VCR/DVD FUNCTION button, which changes the
mode
PIP buttons to VCR mode (page 24 for remote Y181, page 26 for
remote Y182).
There is no window _ Be sure your PIP window picture is set to a video source/channel
picture or it is just that has a program airing.
static ru
You may be tuned to a video input with nothing connected to it.
Try cycling through your video inputs using the yellow PIP TV/
VIDEO button with the red dot (page 26 for remote Y182, page 24
for remote Y181).
I get the same _ Both may be set to the same channel. Try changing channels in
program in the either the main picture or the window picture (page 26 for remote
window picture as Y182, page 24 for remote Y181).
in the main picture _ Your TV may be set up to select all your channels through a cable
box. The cable box will only unscramble one signal at a time, so
you cannot use the PIP feature. If possible, run a direct cable to the
VHF/UHF jack on your TV. This will only work if your cable
system provides an unscrambled signal (page 12).
53