Basic Operation; Advance Operation - Panasonic WH-SXH09D0E8 Operating Instructions Manual

BASIC OPERATION

OFF / ON
TO TURN ON OR OFF THE UNIT
• When unit is ON, operation LED is lit and the actual temperature for water outlet and outdoor ambient are shown on the
control panel display.
• The outdoor unit will provide heating capacity to the indoor unit.
QUIET
TO ENJOY QUIET ENVIRONMENT
• This operation reduces outdoor unit noise. In this condition, it may cause decrease in heating capacity.
STATUS
CHECK
SYSTEM STATUS CHECK MODE
SEARCH
CHECK
1. Press for 5 seconds to enter STATUS mode.
2. Press or to check the Water Inlet Temperature, Compressor Running Frequency or Error History.
CANCEL
• Press to exit STATUS mode.
• Once STATUS mode is entered, "STATUS" indicator is ON.
• STATUS mode cannot be activated when the "SETTING" indicator is ON.

ADVANCE OPERATION

• It is strongly recommended to contact the nearest authorized dealer to change the water temperature range.
• Using the control panel could set the temperature range for water outlet temperature and outdoor ambient temperature.
SET
1. Press for 5 seconds to enter "SETTING" mode.
"SETTING" indicator is ON.
2. Press or to choose a parameter.
3. After selecting the desired parameter,
SELECT
press to enter the parameter.
4. Press or to set the desired temperature.
SET
5. Press again to confi rm the setting.
• Repeat steps 2 to 5 to set other parameters.
Operation
Parameter * Description
Mode
HEAT Low outdoor ambient set temperature (-15°C ~ 15°C).
HEAT High outdoor ambient set temperature (-15°C ~ 15°C).
Water outlet set temperature at low outdoor ambient
HEAT
temperature (25°C ~ 55°C).
Water outlet set temperature at high outdoor ambient
HEAT
temperature (25°C ~ 55°C).
Heating OFF selection (YES/NO)
HEAT
OFF
Set temperature for turning OFF heating operation (-20°C ~ -5°C).
WATER TEMPERATURE THERMO SHIFT SETTING
SET
1. Press within 5 seconds.
• Repeat steps 3 to 5 to set the desired shift temperature (-5°C ~ 5°C).
Notes:
CANCEL
• Press or wait 30 seconds to exit "SETTING" mode.
• The setting temperature will be stored in the system once confi rm.
• "SETTING" mode cannot be activated when the "PUMPDW" and "STATUS" indicator is ON.
SYSTEM SETTING MODE
SETTING
SET
TIMER
HEAT
SELECT
ON
CANCEL
QUIET
OPERATION
Parameter *
Water
Temperature
Temperature display
OUTDOOR
ACTUAL
BOOSTER
C
SETTING
STATUS
PUMPDW
WATER OUTLET
SETTING indicator
Outdoor
Temperature
5