Adjusting Speakerphone Volume; Adjusting The Ring Volume; Speakerphone Tips; Using The Hold Key - Teledex OPAL 1010S Owner's Manual

USING THE SPEAKERPHONE
With the handset in the cradle, press the SPEAKER key. The Opal will
select the ringing line and answer with the speakerphone active.
Note: The red SPEAKER LED will indicate that the speakerphone is active.

ADJUSTING SPEAKERPHONE VOLUME

Locate the slide switch (labeled SPKR VOL) on the right side of the tele-
phone.
To increase speaker volume, slide the switch towards the back of the tele-
phone.
To decrease speaker volume, slide the switch towards the front of the tele-
phone.

ADJUSTING THE RING VOLUME

Locate the adjustment control on the back of the telephone labeled RINGER
LOW/HI (see diagram on page 6). Slide the switch to the desired LOW or HI
ring volume.

SPEAKERPHONE TIPS

TO ACTIV ATE THE HANDSET FROM SPEAKERPHONE MODE:
1. Lift the handset from the cradle.
2. The red SPEAKER LED will go out.
TO ACTIV ATE THE SPEAKERPHONE FROM HANDSET MODE:
1. Press the SPEAKER key.
2. The red SPEAKER LED will indicate speakerphone selection.
3. Place the handset back into the cradle.

USING THE HOLD KEY

The HOLD key places the call on hold locally at the Opal telephone.
TO PLACE A CALL ON HOLD
1. With a call active press the red HOLD key.
2. The red line LED will change to a slow blink indicating the call is on
hold.
TO REMOVE A CALL FROM HOLD
1. Lift the handset from the cradel. This will remove the call from hold
making the call active on the handset.
O R
With the handset in the cradle, press the SPEAKERPHONE key. This will
remove the call from hold making the call activate the speakerphone.
2. The red line LED will return to steady in-use condition.
2