Table of Contents
Advertisement
FIRST TIME INSTALLATION
Channel Search
The Channel Search procedure can be performed in different
ways.
• If there are predefined channels, you can make an Automatic
Search.
• If no predefined channel is available you can make a Manual
Search.
Manual Search
When you perform a Manual Search you first need to enter some
parameters for the channel search to work.
The information you need to enter in this menu is available in
magazines covering satellite TV reception, on the Internet or from
your Service Provider.
Transponder frequency: Specify the frequency in GHz. If you
enter the wrong figure(s), erase with the
Polarization: Select Horizontal, Vertical, Circular left or Circular
right.
Symbol rate (MSym/s): Enter with the numeric buttons. If you
enter the wrong figure(s), erase with the
FEC: Select "Auto" or any of the preprogrammed values.
Network Search: Select "Yes" if you want to search on all trans-
ponders connected to a specific network.
Press OK to start searching for channels.
Signal Strength (AGC) and Signal Quality (SNR)
The different signal indicators above the information bar provide
information about two things:
AGC: The AGC will indicate the average strength of any incom
ing signal, digital as well as analogue.
SNR: The SNR indicates the signal quality from that specific
channel.
When the search is finished, information about how many chan-
nels where found will appear on the screen.
• Press OK to continue.
Time Adjustment
The time is adjusted by using the
time.
You can also adjust the minutes by using the
• Press OK and you are ready to watch TV.
button.
button.
buttons, 1/2 an hour at a
buttons.
GB 13
Advertisement
Table of Contents
