Remote Control - Pioneer XC-L77(DU-L77) Operating Instruction

3 What's What

Remote Control

18
REMOTE LOCATOR
ON OFF
17
Remote Locator
This remote control has a
feature that will allow you
to locate it if you've mislaid
it in the room. When remote
locator is switched on,
clapping at least three times
within the space of about a
second will cause the
remote control to beep.
This should help you to
locate it.
Although a useful function,
leaving the remote locator
on all the time reduces the
battery life of the remote.
For this reason, an on/off
slider switch is provided on
the rear.
When switched on, the
remote will sometimes beep
if knocked or dropped —
this is not a malfunction.
14
1 2 3 4
AUX/CD-R SOUND DISPLAY
STANDBY/ ON
15
16
1 MENU – Press to access various features, including station memory
2 Tape deck mode – Press to switch the sound to tape deck and start the
3 SOUND – Press to put the $ and › buttons into tone, subwoofer
4 DISPLAY – Press to change the kind of information that the display shows.
5 SET – Press to finish operations such as setting the clock, setting the reverse
6 MD REC – Press to put MD recorder into record-pause mode.
7 TAPE REC – Press to put tape deck into record-pause mode.
8 TIMER/CHARACTER – Press to start setting the timer. Also use to select
9 & CANCEL – Press to stop playback (or recording) of the CD/MD/tape.
10 $ › buttons – Press to fast-reverse / fast-forward the CD/MD/tape.
1 1 CD mode – Press to switch the sound to CD and start the disc playing (if
12 Up – Use to raise the volume.
13 Down – Use to lower the volume.
14 Tuner mode – Press to switch the sound to tuner, switch between AM and
15 MD mode – Press to switch the sound to MD and start the disc playing (if
16 Power – Press to switch the unit between standby and on modes.
17 AUX/CD-R mode – Press to switch the sound to the component
18 REMOTE LOCATOR – Use to switch on/off remote locator (see box,
5 6 7 8
SET MD TAPE TIMER/
REC CHARACTER
naming, changing the tape reverse mode, and so on.
tape playing (if there's one loaded).
level and balance control mode.
The choices available depend on the current function (CD, tape, etc.).
mode, and so on.
characters when naming tuner station memories, etc.
Also use to cancel operations, such as setting the clock, before the SET
button has been pressed (see 5 above).
there's one loaded).
FM, and switch between preset station memories.
there's one loaded).
Note: this unit consumes about 1W of electricity in standby mode.
connected to the AUX/CD-R inputs.
left).
9 10 1 1 12
& $ ›
VOL
! — + ⁄
CANCEL
14 13