Using The Remote Controller (Rm-Rk50) - JVC KD-R900 Instructions Manual

• BT FRONT/BT REAR (Audio) : Pause
playback.
w
• Enter "Call Menu" screen.
• Enter <Quick Call> preset method [Hold]. (See
page 36.)
• BT FRONT/BT REAR (Phone):
– Answer incoming call.
– End a call [Hold].
e
• Turn on the power.
• Attenuate the sound (if the power is on).
• Turn off the power [Hold].
• BT FRONT/BT REAR (Phone): Switch
the conversation media during a phone call
conversation.
r
Remote sensor
t
AUX (auxiliary) input jack
* 1
Also known as "Control dial" in this manual.

Using the remote controller (RM-RK50)

Installing the lithium coin battery (CR2025)
For USA-California Only:
This product contains a CR Coin Cell Lithium Battery
which contains Perchlorate Material—special
handling may apply.
See www.dtsc.ca.gov/hazardouswaste/perchlorate
* 2
You can still adjust the volume during pause when the
selected source is CD/USB FRONT/USB REAR/
iPod FRONT/iPod REAR/BT FRONT/BT
REAR/iPod.
Before resume playback, check to be sure that you
have not raise the volume level too much.
3
* For Bluetooth devices that support AVRCP 1.3.
4
* When the HD Radio tuner box is connected, the
built-in tuner of this unit will be disabled. To listen
to the HD Radio broadcast, refer to "Listening to the
radio" on pages 9 and 10. For more features, see
pages 19 and 20.
* 5
You cannot select these sources if they were disabled
in the <SET UP> menu (see <Source Select> in
"Menu operations" on page 33).
6
* You cannot select these sources if they are not ready
or not connected.
* 7
You can use this function only when <iPod Mode>
is available for the connected iPod (see pages 24 and
41).
Caution:
• Danger of explosion if battery is incorrectly replaced.
Replace only with the same or equivalent type.
• Battery shall not be exposed to excessive heat such as
sunshine, fire, or the like.
If the effectiveness of the remote controller
decreases, replace the battery.
Before using the remote controller:
• Aim the remote controller directly at the remote
sensor on the unit.
• DO NOT expose the remote sensor to bright light
(direct sunlight or artificial lighting).
Remote sensor
OPERATIONS
Continued on the next page
7