Inspection, Maintenance, And Cleaning; Troubleshooting - Central Pneumatic CENTRALPNEUMATIC 97526 Assembly And Operating Instructions Manual

INSPECTION, MAINTENANCE, AND CLEANING

1. WARNING! Make sure air compressor is unplugged and that the Nailer is
disconnected from its Air Supply before performing any inspection, maintenance,
or cleaning procedures.
2. BEFORE EACH USE, inspect the general condition of this tool. Check for
loose screws, misalignment or binding of moving parts, cracked or broken parts,
damaged air hoses, and any other condition that may affect its safe operation. If
abnormal noise or vibration occurs, have the problem corrected before further use.
Do not use damaged equipment.
Inspect the Nailer for damage
(see #2, above)
Wipe off with clean, moist
cloth
Problem
Air leak near top of
tool or in trigger area.
Nailer does not
operate or operates
sluggishly
Air leak near bottom
of Nailer
Nailer jam frequently
Other
SKU 97526 For technical questions, please call 1-800-444-3353.
MAINTENANCE CHART
Maintenance Type

TROUBLESHOOTING

Possible Causes
1. Loose screws.
2. Worn or damaged o-rings or seals.
1. Inadequate air supply.
2. Inadequate lubrication.
3. Worn or damaged o-rings or seals.
1. Loose screws.
2. Worn or damaged o-rings or
bumper.
1. Incorrect fasteners.
2. Damaged fasteners.
3. Magazine or Nozzle screw loose.
4. Magazine is dirty.
5. Driver is worn or damaged.
Before After
Use Use
X X
X
Probable Solutions
1. Tighten screws.
2. See qualified service technician for
repairs.
1. Check screws.
2. See qualified service technician for
repairs.
1. Tighten screws.
2. See qualified service technician for
repairs.
1. Check fasteners for correct size.
2. Replace with undamaged
fasteners.
3. Tighten screws.
4. Clean screws.
5. See qualified service technician for
repairs.
See qualified service technician for
repairs.
Monthly
X
Page 7