Troubleshooting - Central Pneumatic 98733 Set Up And Operating Instructions Manual

21° angle framing nailer contractor series

Hide thumbs

Table Of Contents

Table of Contents

Problem

Air leaking in

1. Loose Screw (6).

Cylinder Cap (8A).

2. O-ring (9A) is cracked or worn.

Lack of power.

1. Tool is too dry.

Slow to cycle.

Low power when

2. Air pressure too low.

shooting and

returning.

3. Exhaust blocked.

Not shooting

1. Damaged Torsion Spring (76).

fasteners or

2. Wrong size of fasteners.

only intermittent

feeding.

3. Magazine (71) is dirty.

Fastener is

1. Feeder Shoe (69) is broken or

jammed in tool.

2. Bent fasteners.

Follow all safety precautions whenever diagnosing or servicing the

tool. Disconnect air supply before service.

THE MANUFACTURER AND/OR DISTRIBUTOR HAS PROVIDED THE PARTS LIST AND ASSEMBLY DIAGRAM

IN THIS MANUAL AS A REFERENCE TOOL ONLY. NEITHER THE MANUFACTURER OR DISTRIBUTOR MAKES

ANY REPRESENTATION OR WARRANTY OF ANY KIND TO THE BUYER THAT HE OR SHE IS QUALIFIED

TO MAKE ANY REPAIRS TO THE PRODUCT, OR THAT HE OR SHE IS QUALIFIED TO REPLACE ANY PARTS

OF THE PRODUCT. IN FACT, THE MANUFACTURER AND/OR DISTRIBUTOR EXPRESSLY STATES THAT

ALL REPAIRS AND PARTS REPLACEMENTS SHOULD BE UNDERTAKEN BY CERTIFIED AND LICENSED

TECHNICIANS, AND NOT BY THE BUYER. THE BUYER ASSUMES ALL RISK AND LIABILITY ARISING OUT OF

HIS OR HER REPAIRS TO THE ORIGINAL PRODUCT OR REPLACEMENT PARTS THERETO, OR ARISING OUT

OF HIS OR HER INSTALLATION OF REPLACEMENT PARTS THERETO.

SKU 98733