Operation Switching On The Machine - Nilfisk-ALTO SV 8000 Operating Instructions Manual

Operating Procedure
.........................................................
1. Fill the cold water tank (Number 7 Diagram A) with clean cold water only.
!!
Anything other than clean cold water used in the
water tank will void the manufacturers warranty.
2. Connect the Vacuum Hose to the front of the machine (Number 2 Diagram A) ensuring
it locks into position. To release the vacuum hose from the socket slide the red button
upwards at the same time as pulling the hose out.
!!
If the Hose becomes damaged the complete hose must be replaced. Do not
attempt this task yourself, contact a Nilfisk ALTO approved supplier for
replacement.
3. Connect the Steam Hose to the front of the machine (Number 3 Diagram A) ensuring it
is pushed in all the way and the pin on the flap locks into the hole on the hose.
!!
Grease "O" rings on steam pin before connecting.
!!
To release the steam hose, lift the flap and pull.
4. Plug the power cable into a 240 Volt supply.
!!
Inspect the electric cable before every use. If the cable becomes damaged at
anytime the complete cable must be replaced by a Nilfisk ALTO approved
distributor.
!!
Never touch the power cable or plug with wet hands
!!
Always unplug the machine when
iii. Any maintenance work is being carried out
8. Switch the On/Off switch (Number 10 Diagram B) to the ON position. The Heater On
light LED (Number 11 Diagram B) will illuminate.
9. Allow approximately 10 minutes for the boiler to heat the water
10. When the Steam Ready LED (Number 12 Diagram B) illuminates the machine is ready
to be used.
i. The machine is not in use
ii. Cleaning the machine
English
9