Panasonic LUMIX DMC-FZ38 Operating Instructions Manual page 203

[READ ERROR/WRITE ERROR
PLEASE CHECK THE CARD]
•
It has failed to read or write data.
> Remove the card after turning the power [OFF]. Insert the card again, turn the power on,
and try to read or write the data again.
•
The card may be broken.
> Insert a different card.
[MOTION RECORDING WAS CANCELLED DUE TO THE LIMITATION OF THE
WRITING SPEED OF THE CARD]
•
It is recommended to use a card with SD Speed Class
recording motion pictures.
¢ SD speed class is the speed standard regarding continuous writing.
•
When you set the picture quality to [
card with "10MB/s" or greater displayed on the package.
•
In the event that it stops even after using a "10MB/s" card or higher, the data writing speed has
deteriorated so it is recommended to make a backup and then format (P37).
•
Depending on the type of SD Memory Card or SDHC Memory Card, motion picture recording
may stop in the middle.
[THIS CARD IS NOT FORMATTED WITH THIS CAMERA, AND NOT SUITABLE FOR
MOVIE RECORDING.]
•
The writing speed is lower if the card has been formatted using a PC or other equipment. As a
consequence, motion picture recording may stop in the middle. If this happens, make a
backup of the data and format
[A FOLDER CANNOT BE CREATED]
•
A folder cannot be created because there are no remaining folder numbers that can be used.
(P183)
> Format the card after saving necessary data on a PC etc.
[NO.RESET] in the [SETUP] menu after formatting, the folder number is reset to 100.
(P34)
[PICTURE IS DISPLAYED FOR 16:9 TV]/[PICTURE IS DISPLAYED FOR 4:3 TV]
•
The AV cable is connected to the camera.
> Press [MENU/SET] if you want to delete this message at once.
> Select [TV ASPECT] in the [SETUP] menu if you want to change the TV aspect.
•
This message also appears when the USB connection cable is connected to the camera only.
In this case, connect the other end of the USB connection cable to a PC or a printer. (P180,
184)
[PRINTER BUSY]/[PLEASE CHECK THE PRINTER]
•
The printer cannot print.
> Check the printer.
[NO BATTERY POWER REMAINS]
•
The remaining battery power is low.
> Charge the battery.
Others
], [ ] or [
(P37) the card in this unit.
- 203 -
¢
with "Class 6" or higher when
], we recommend using a high-speed
(P37) If you execute
(P36)