Panasonic LUMIX DMC-FZ38 Operating Instructions Manual page 109

Start recording by pressing the motion
picture button.
A Available recording time
B Elapsed recording time
•
The audio is also recorded simultaneously from the
built-in microphone on this unit. (Motion pictures
cannot be recorded without audio.)
•
The recording state indicator (red) C will flash while recording motion pictures.
•
Focus can be achieved during recording by pressing [FOCUS].
•
Focus can be set manually when [
Stop the recording by pressing the motion picture button again.
•
Sound will go off when pressing the motion picture button indicating start/stop of motion
picture recording.
Sound volume can be set in [BEEP LEVEL] (P30).
•
If the built-in memory or the card becomes full in the middle of recording, the camera
stops recording automatically.
Note
•
The screen will change as following when the motion picture button is pressed in steps
4
.
A Still picture recording
screen
B Motion picture mode
¢1
setting
C Motion picture
recording screen
D Still picture mode
¢2
setting
¢1 The screen that is displayed during motion picture mode setting is different depending on the
[REC MODE]
setting of the
¢2 [!] will not be displayed in the Creative Motion Picture Mode.
Advanced (Recording pictures)
MF
] is displaying.
5 5
.
- 109 -
A
C
B
(P83)
3
and
R1m19s R1m19s R1m19s
3s 3s 3s