Specifications; Unpacking; Installation - Greyhound 96156 Installation, Operating And Servicing Instructions

sPecIFIcatIons

Engine Rating
Type
Fuel
Capacity
Type
Engine Oil
Capacity
Run Time @ 50% Load 3.5 Hours with full tank
Sound Level
Engine Type
Bore x Stroke
Compression Ratio
Displacement
Rotation
viewed from PTO
(power takeoff - the output shaft)
Shaft Size/Type
Type
Spark Plug
Gap
Intake
Valve
Clearance
Exhaust
Speed
The emission control system for this
engine is warranted for standards set by the
U.S. Environmental Protection Agency. For
warranty information, refer to the last pages of
this manual.
At high altitudes, the engine's carburetor
and any other parts that control the fuel-air
ratio will need to be adjusted by a qualified
mechanic to allow efficient high-altitude use
and to prevent damage to the engine and any
other devices used with this product.

unPacKInG

When unpacking, make sure that the
item is intact and undamaged. If any parts
are missing or broken, please call Harbor
Freight Tools at 1-800-444-3353 as soon as
possible.
Page 6
5.5 Horsepower
89+ octane unleaded gasoline
0.45 Gallons
10W-30
(Detergent or non-detergent)
18.6 oz.
77 dB
4 Stroke, OHV
(1P68FV / 7CLGS.16368V)
68 mm x 45 mm
8:1
163cc
Counterclockwise
7/8" x 3-1/8", 3/16" keyway,
end tapped 3/8"-24
F6TC resistive
®
(NGK BP-6HS, Champion
0.028"-0.031"
0.1 mm
0.15 mm
3250 RPM
For technical questions, please call 1-800-444-3353.
read the entIre IMPortant
saFetY InForMatIon
section at the beginning of this
manual including all text under
subheadings therein before
installation or use of this product.
®
RL86C)
1. IMPortant:
about your ability to perform the following
procedures, have a qualified service
technician perform the installation.
2. Install this engine on a lawn mower only.
Figure a - Mounting Hole Locations
3. Set the Engine upright on the mower,
and align the four 3/8" diameter coarse
threaded engine mounting holes with

InstaLLatIon

to Prevent
serIous InjurY
FroM accIdentaL startInG:
close the engine's fuel valve,
wait for the engine to cool, and
disconnect the spark plug wire(s)
before installing or making any
adjustments to the engine.
to Prevent
serIous InjurY:
operate only with proper spark
arrestor installed.
operation of this engine may
create sparks that can start fires
around dry vegetation.
a spark arrestor may be required.
the operator should contact
local fire agencies for laws or
regulations relating to fire
prevention requirements.
If you have any doubts
(Bottom view)
SKU 96156