Setting Up The Telephone For Use - Gigaset C360 User Manual

All electrical and electronic equipment should
not be disposed of separately from general
household waste using the sites designated by
local authorities.
The appropriate disposal and separate collec-
tion of used equipment serve to prevent poten-
tial harm to the environment and to health.
They are a precondition for the re-use and recy-
cling of used electrical and electronic equip-
ment.
For further information on disposing of your
used equipment, please contact your local
authority, your refuse collection service or the
dealer you purchased the product from.
Emergency numbers cannot be dialled if the key lock
(page 1) is activated!
Not all of the functions described in this user guide are
available in all countries.

Setting up the telephone for use

Step 1: Connecting the base station
1
First connect the mains unit (230 V) to power
1
cord and then connect the phone jack to phone
2
cord , as shown above. Place the cords in the cord
recesses. The two cords must be plugged in at all
times.
◆
Only use the mains unit supplied.
◆
If you ever purchase another phone cord from
a store, ensure that the phone conductors are
correctly connected: 3-4 connection of the tele-
phone conductors.
2
Step 2: Setting up the handset
Note:
The display is protected by a plastic film.
Please remove the protective film!
Fitting the battery pack
◆
Place the battery leads in the cable guides so
that the battery cover cannot catch on the leads
and damage them when it is closed.
◆
Use only the rechargeable battery pack rec-
ommended by Gigaset Communications GmbH *
(page 8), i.e. never use a conventional (non-
rechargeable) battery pack as this may cause sig-
nificant damage to health and property. For
example, the outer casing of the battery pack
could be destroyed or the battery pack could
explode. The phone could also malfunction or be
damaged as a result of using batteries that are not
of the recommended type.
◆
Only use the battery charger supplied.
◆
Only place the handset in the charging cradle
that is intended for it.
* Gigaset Communications GmbH is a trademark
2
licensee of Siemens AG.
◆
Insert the plug into the socket as shown in the
enlarged view.
◆ Insert the battery pack.
◆
Place the cords in the cord routing.
Closing the battery cover
Insert the cover into the top end of the battery
compartment and press down until it clicks into
place.
Opening the battery cover
Place your fingernail between the cover and the
housing and pull the cover upwards.