SPYKER 80 Operation Manual Service Manual Parts List

SPYKER 80 Operation Manual Service Manual Parts List

Spreading chart

Advertisement

Quick Links

LIMITED WARRANTY

This is warranted to the original purchaser only, other than used
commercially, against defects in materials and workmanship,
for a period of one year from the date of purchase.
*For Spyker Spreaders LLC, products employing metal gear
systems, pinion and bevel, these metal gears, only, not inclusive
of any other parts or materials, are warranted for the life of
the spreader, not to be used for replacement or repair past
original purchase.
Spyker Spreaders LLC will not be liable for any loss, damage
or expense including, but not limited to, consequential or
incidental damages, arising from the operation, condition or use
of the item. The sole and exclusive remedy against Spyker
Spreaders LLC being the replacement of the defective parts.This
warranty gives you specific legal rights, and you may also have
other rights which vary from state to state.
THIS EXPRESS WARRANTY, WHICH IS APPLICABLE ONLY TO
THE ORIGINAL PURCHASE, IS IN LIEU OF AND EXCLUDES ALL
OTHER WARRANTIES, WHETHER EXPRESSED OR IMPLIED BY
OPERATION OF LAW OR OTHERWISE, INCLUDING ANY
WARRANTY OF MERCHANTABILITY OR FITNESS FOR
PARTICULAR PURPOSE.
SPYKER SPREADERS LLC
P.O. Box 7
• Urbana, IN
© 2004 Spyker Spreaders – Urbana, IN U.S.A.
46990
USA
05-80-0000 AP
spread with confidence
spread with confidence
For Models:
80
125
175
Model 80 pictured
P.O. Box 7 • 140 Mill St.
Urbana, IN • 46990
USA
Spreading Chart
Operation Guide
Service Manual
1-800-972-6130
Fax: 260-774-3416

Advertisement

Table of Contents
loading

Summary of Contents for SPYKER 80

  • Page 1: Limited Warranty

    Spyker Spreaders LLC will not be liable for any loss, damage or expense including, but not limited to, consequential or incidental damages, arising from the operation, condition or use of the item.
  • Page 2: Frame Assembly

    (2) Tow Bar Brace Attach frame to • (1) Manual hopper using 4 MODEL 80 bolts (24), nylon washers (33) which Note the Spyker logo on the go on inside of hop- front side of hopper. per and nuts (25).
  • Page 3: Axle Assembly

    (13) loosely slide into hole on to cross-bar of frame leg. frame using 1 bolt [24] [use bolt (44) for model 80] & nut [25]. Attach 2 braces (36) as shown using 3 bolts (24) and 3 nuts (25).
  • Page 4: Final Assembly

    Rate Gate Assembly Final Assembly Place felt washer (22) Attach on/off over spinner control cable [37] shaft. to control bar with 2 bolts [31] & 2 nuts [29]. Put end cap (30) on lever control bar. Insert agitator wire (28) into spinner shaft.
  • Page 5: Read Before Using

    Rate Dial Adjustment Read Before Using New Linkage Adjustment Procedure SPEED - ACCURACY - FREEDOM FROM STRIPES AND STREAKS are yours - when you use this Spreader. 1. Set regulator dial to 1. The spread width ranges from 4 ft. to 12 ft. wide, depending on the volume/density, particle size of the material and the rate of travel.
  • Page 6 Read Before Using Read Before Using Rotary Agitator RECOMMENDATION: When not spreading and the spreader is being pushed some distance, tip the spreader so only the idle wheel is on the ground. Use the rotary agitator only if needed. Free-flowing, lump-free materi- als will not require the agitator.
  • Page 7 Read Before Using Read Before Using Accuway - What It Does The Accuway has two ramps. A front side and a back side ramp. Viewed from operators position. Accuway Spread Pattern Equalizer Balances the spread pattern - Bulls Eye - Dead to the Center of the Spreader. All The front side ramp is used to shift the spread pattern to the right.
  • Page 8: Did You Know

    The hand The seed sower was a ing products. New 12 oz. 1,000 cast method of seed- breakthrough in field Spyker's Accuway ® products and product ing was a limited fac- seeding. It was hailed spread pattern equal- forms adapted to...

This manual is also suitable for:

125175

Table of Contents