Lathe Safety Warnings - Central Machinery 65345 Set Up And Operating Instructions Manual

parts, breakage of parts and any
other condition that may affect the
power tool's operation. If dam-
aged, have the power tool repaired
before use. Many accidents are
caused by poorly maintained power
tools.
Keep cutting tools sharp and
f.
clean. Properly maintained cutting
tools with sharp cutting edges are
less likely to bind and are easier to
control.
use the power tool and its acces-
g.
sories in accordance with these
instructions, taking into account
the working conditions and the
work to be performed. Use of the
power tool for operations different
from those intended could result in a
hazardous situation.
5. Service
a. Have your power tool serviced by
a qualified repair person using
only identical replacement parts.
This will ensure that the safety of the
power tool is maintained.

Lathe Safety Warnings

1. Maintain labels and nameplates on
the Lathe. These carry important
safety information. If unreadable or
missing, contact Harbor Freight Tools
for a replacement.
2. Do not run the Lathe without its cov-
ers and guards in place.
3. Tighten all locks before operating.
4. Do not mount a split workpiece.
5. Use the lowest speed when starting a
new workpiece.
SKU 65345 For technical questions, please call 1-800-444-3353.
6. Always stop the Lathe at its slow-
est speed. If the Lathe is run so fast
that it vibrates, there is a risk that the
workpiece will be thrown or the cut-
ting tool jerked from your hands.
7. Always rotate the workpiece by hand
before turning on the Lathe. If the
workpiece strikes the tool rest, it
could split and be thrown out of the
Lathe.
8. Do not allow cutting tools to bite into
the workpiece. The wood could be
split or thrown from the Lathe.
9. Always position the tool rest above
the centerline of the Lathe when
shaping a piece of stock.
10. Before attaching a workpiece to the
faceplate, always rough it out to
make it as round as possible. This
minimizes the vibrations while the
piece is being turned. Always fasten
the workpiece securely to the face-
plate. Failure to do so could result
in the workpiece being thrown away
from the Lathe.
11. Remove all loose knots in the work-
piece before mounting between the
centers or on the faceplate.
12. Position your hands so they will not
slip onto the workpiece when the
Lathe is running.
13. Use a brush or compressed air to
remove wood shavings; never your
hands. The wood shavings will be
sharp.
14. The cutting tool must always be tight
within the tool post or chuck and
adjusted to limit projection from the
post. This will reduce the possibility
of the tool breaking or bending.
Page 5