Panasonic PV-DV702-K Operating Instructions Manual page 77

Palmcorder USB Device Driver/SD Drive
For Windows 2000 users
3
Connect the Palmcorder to your PC (Windows) using the USB Cable (supplied).
• "CONNECT WITH PC" appears in the EVF or the LCD monitor.
• The "Found New Hardware" screen of Windows is displayed.
• When the Palmcorder and PC (with Windows 2000) are connected via USB, a
message, such as the one below, is displayed.
The following message is displayed. However, testing by the manufacturer
has confirmed functionality of this Palmcorder with Windows XP/2000.
Click [Yes] and proceed.
Note
• For extended use, the AC Adaptor should be used as a power source.
For Windows 98SE/Me users
3
Connect the Palmcorder to your PC (Windows) using the USB Cable (supplied).
• "CONNECT WITH PC" appears in the EVF or the LCD monitor.
Note
• For extended use, the AC Adaptor should be used as a power source.
To disconnect USB Cable safely (Windows Me/2000/XP)
If USB Cable is disconnected while computer is on, error message may appear. In such a
case click [OK] and close the dialog box. By following the steps you can disconnect the
cable safely.
[ This screen is an example (Windows 2000) ]
DV702-K.p 76-78.p65
1
Double-click the
tray.
2
Select [USB Storage Device
Controller]* and click [Stop].
3
Verify [USB Storage Device
Controller]* is selected and click
[OK].
4
Click [OK].
• You can safely disconnect the cable.
* If you are using Windows Me, [USB
Disk] will be displayed.
Note
• Some OS, such as Windows 98SE, may
not show the icon indication that you may
safely disconnect in task tray. (OS may
be set not to show) After the [ACCESS]
display disappears from the EVF or LCD
monitor you may disconnect the USB
Cable.
77
icon in the task
77
02/06/06, 13:58