Tuner Mode - Sanyo DMP-P3 Instruction Manual

Sleep Function
This function switches the unit from operation mode to STANDBY mode after the
specified time. (Supports AM / FM mode only).
1. Press and hold the SLEEP button to turn the unit on and press HOUR and MIN
buttons to set the sleep time.
2. The sleep time ranged from 1 minute to 1 hour 59 minutes.
3. Having set the sleep time, press SLEEP button to reset the sleep time to 59
minutes.
4. Press the SNOOZE button to cancel SLEEP function.
Note:
1).Sleep function would not be able to turn off the iPod. In this case, once the
sleep function is activated, the speaker of the unit will mute but the iPod will
keep on playing.
2).This function is only available when the function setting to OFF position.
Dimmer Function
The brightness of the display can be controlled by sliding the DIMMER switch to
HIGH / LOW position.
Radio Antenna
1. The FM antenna is located at the back of the unit. If FM is weak, extend the
FM antenna to its full length or try varying the position and direction of the FM
antenna until you find the strongest signal.
2. The AM bar antenna is built-in inside the unit. If AM reception is weak, change
the position of the unit until the internal antenna picks up the strongest signal.
Listening to Radio
1. Slide the FUNCTION switch to ON position.
2. Select AM / FM mode by sliding the MODE switch.
3. Tune to the desired radio station by rotating the TUNING WHEEL.The related
frequency is displayed beneath the TUNING LENS.
4. To turn off the radio, slide the FUNCTION switch to OFF position to switch the
unit into standby mode.

TUNER MODE

-8-