Turntable Installation; Charcoal Filter Installation; Grease Filter Installation - Sanyo EM-S9000 Instruction Manual And Cooking Manual

Over-the-range microwave oven
Table of Contents

Advertisement

S9000sci-assembly.fm Page 9 Wednesday, September 22, 1999 2:38 PM

TURNTABLE INSTALLATION

Turntable
Roller rest
Receptacle
1. Place the roller rest on the cavity
bottom.
2. Place the turntable on top of the
roller rest as shown in the
diagram. Make sure the turntable
hub is securely locked in the
receptacle.

CHARCOAL FILTER INSTALLATION

If the microwave oven has been
installed for room venting, the air
vented by the fan will be recirculated
back into the room through a pair of
disposable charcoal filters that help to
remove smoke and odors. If these filters
become excessively dirty or discolored,
they should be replaced. Under normal
conditions, these filters should be
replaced once every 6 to 12 months.
Charcoal Filter Kit (EMA-400)
If replacement charcoal filters are not
available from an authorized dealer in
your area, call 1-800-263-2244 for parts
ordering information. (See page 44 for
more details).

GREASE FILTER INSTALLATION

The reusable metal grease filters trap
grease released by food on the
cooktop. They also prevent flames
from food on the cooktop from
damaging the inside of the oven.
• Never place the turntable upside
down. The turntable should never
be restricted.
• Both turntable and roller rest must
always be used during cooking.
• All food and containers of food
must always be placed on the
turntable for cooking.
Hub (underside)
• The turntable returns to its original
starting position when cooking is
finished. The light and fan will
remain on but microwave power is
turned off.
• The turntable rotates clockwise and
counterclockwise; this is normal.
• If turntable or roller rest cracks or
breaks, contact your nearest
authorized service center for more
information regarding replacement.
1. Disconnect the power supply.
2. Insert one end of the filter into the
back of the opening
3. Push it up
you
1. Disconnect the power supply.
2. Hold the filter with the ring end
facing you.
3. Insert the other end into the back
of the opening.
4. Slide the filter towards the front
and side until it is securely in
place.
9
.
1
and slide it towards
2
until it hangs in place.
3
2
1
3
Fig 42

Advertisement

Table of Contents
loading

Table of Contents