Care And Cleaning - Sanyo EM-S9000 Instruction Manual And Cooking Manual

S9000sci-Maint.fm Page 42 Wednesday, September 22, 1999 2:40 PM

CARE AND CLEANING

Wipe the oven inside and outside
with a soft cloth and a mild detergent
solution. Then rinse and wipe dry.
This should be done on a weekly
basis, more often if needed. Never
use cleaning powders or rough pads.
Excessive oil splatters on the inside
top will be difficult to remove if left for
many days. Wipe splatters with a wet
paper towel, especially after cooking
chicken or bacon.
Stubborn messes: Boil a cup of water
in the oven for 2 minutes. Steam will
soften the mess. To get rid of odors
inside the oven, boil a cup of water
with some lemon juice in it.
REMOVABLE PARTS
The following parts may be removed
as described. They should be washed
in warm (not hot) water with a mild
detergent and a soft cloth. Once they
are clean, rinse them well and dry
with a soft cloth. Never use cleaning
powders, steel wool or rough pads.
• The turntable may be cleaned in
the sink. Be careful not to chip or
scratch the edges as this may
cause the turntable to break
during use.
• The turntable roller rest should be
cleaned regularly.
• The metal grease filters should be
cleaned once a month or as
needed. Soak grease filters in hot
water and a mild detergent. Scrub
to remove embedded dirt and
grease. Rinse well and shake to
dry. Do not use ammonia,
corrosive cleaning agents such as
lye-based oven cleaner, or place
in a dishwasher. The filter will
turn black or could be damaged.
• Metal rack should be washed by
hand with a mild detergent and a
soft sponge or nylon scrub brush.
Dry completely. Do not use
abrasive scrubbers or cleansers.
• After each use of the temperature
probe, wipe with a soft damp
cloth.
SPECIAL CARE
For best performance and safety, the
inner door panel and the oven front
frame should be free of food or
grease buildup. Wipe them often with
a mild detergent. Then rinse and wipe
dry. Never use cleaning powders or
rough pads.
After cleaning the control panel, press
STOP/CLEAR to clear any entries that
might have been entered accidentally
while cleaning the panel.
COOKTOP LIGHT REPLACEMENT
When cooktop light does not light,
replace the bulb. Follow instructions
below for replacement.
1. Disconnect the power.
2. Remove the screw and carefully
remove the cover.
3. Replace bulb with a 40-watt
incandescent bulb available from
an authorized Sanyo Service
Center (see page 44).
4. Replace the cover and put the
screw back in.
5. Plug in oven or reconnect power.
Caution:
Be sure the power is disconnected at
the house circuit breaker or unplug
the power supply cord. If light is
damaged, contact an Authorized
Sanyo Factory Service Center.
42