Connecting To An Electrical Outlet - Panasonic DMC-F7PP Operating Instructions Manual

ª Charging time and available recording time
(when the supplied 8 MB SD Memory card is used)
A Charging time
B Continuous recording time (recordable number) (If the LCD monitor is ON)
C Continuous recording time (recordable number) (If the LCD monitor is OFF)
ª Charging environment and charging error
• Charge the battery in a place with the temperature of 10 to 35 °C. (The battery is
also the same temperature)
• When charging starts, the status indicator blinks at about 2 second intervals. If,
after charging starts, the status indicator blinks quicker, it's a charging error.
In this case, remove the AC adaptor from the electrical outlet, remove the battery
and check if both room and battery temperature is too low or high and then
charge it again. (It is not possible to cancel the error by only turning the camera
off/on) If the problem persists, consult the dealer.
ª Charging the built-in battery for dating
The date/time setting can be memorized using the built-in battery. Charge it
using the AC adaptor for 3 hours approximately. (When inserting the battery,
even if the status indicator finishes blinking, keep charging the built-in battery)
• After the charging, set the date/time. (P25)
• During the charging, do not open the battery door.

Connecting to an Electrical Outlet

If you use an AC adaptor and connect it to an electrical outlet, you can use the
camera without worrying about the battery discharge. The connection method
is the same as explained in [Charging the Battery]. (P14)
• During use, the camera becomes warm, but it is not a malfunction.
15