[Intelligent Iso]; [Sensitivity] - Panasonic Lumix DMC-TZ10 Operating Instructions Manual

Using the [REC] menu
Set quality of picture.
■
Recording Mode:
■
Settings: Fine (High quality, priority to picture quality)
Standard (Standard quality, priority to the number of pictures)
Aspect ratio of still picture can be changed according to printing or playback format.
■
Recording Mode:
■
Settings:
4
3
Same as 4:3 TV or computer Same as normal film camera
●
Edges may be cut off when printing – be sure to check in advance.
●
In ([INTELLIGENT AUTO] Mode),
by changing the [PICTURE SIZE].
Camera automatically adjusts ISO Sensitivity and shutter speed according to movement
of subject to avoid blur. Higher ISO Sensitivity reduces subject blur and jitter but can
increase interference. Please select maximum ISO Sensitivity according to table below.
■
Recording Mode:
■
Settings: [OFF] / / /
Setting guide
Movement of subject Slow
ISO Sensitivity Low
Shutter speed Slow
Interference Low
96
VQT2R48
(Continued)
[QUALITY]
[ASPECT RATIO]
3 16
2
For playback on widescreen/
high definition TV
(11.5M) and (10.5M) may be selected

[INTELLIGENT ISO]

Fast
High
Fast
High
For [REC] menu setting procedures (→20)
●
Slow-moving subject
ISO Sensitivity 200
(Shutter speed 1/30)
●
Shutter speed and ISO Sensitivity are displayed in the screen for a few seconds after
recording.
●
If interference becomes noticeable, we recommend reducing the setting, or setting
[NOISE REDUCTION] in [PICT.ADJ.] in the + direction.
●
Blurring may occur depending on brightness, size, position, and speed of movement of
the subject (e.g. if subject is too small, is on edge of picture, or starts moving as soon
as shutter button is pressed).
●
Scope of flash recording (→48)
9
Set ISO Sensitivity (sensitivity to lighting) manually.
We recommend higher settings to take clear pictures in darker locations.
■
Recording Mode:
■
Settings: [AUTO] / [80] / [100] / [200] / [400] / [800] / [1600]
Setting guide

[SENSITIVITY]

Location
(recommended)
Shutter speed
Interference
●
[AUTO] is automatically set in a range up to 400 (1000 when flash is used) based on
subject movement and brightness.
●
Scope of flash recording (→48)
●
Cannot be set when [INTELLIGENT ISO] is used (
●
If interference becomes noticeable, we recommend reducing the setting, or setting
[NOISE REDUCTION] in [PICT.ADJ.] in the + direction.
●
Fast-moving subject
ISO Sensitivity 800
(Shutter speed 1/125)
[SENSITIVITY]
[80] [1600]
Bright
Dark
(outdoors)
Slow Fast
Low High
is displayed)
97
VQT2R48