Cautions For Use - Panasonic NV-MX350B Operating Instructions Manual

Cautions for Use

After Use
ª
1
Take out the Cassette.
2
Set the [OFF/ON/MODE] Switch to [OFF].
3
Take out the Card.
4
Detach the power supply and retract the
Viewfinder or the LCD Monitor.
5
To protect the Lens, attach the supplied Lens
Cap.
Cautions for Use
ª
When you use your Movie Camera in a rainy or snowy
day or on a beach, make sure that no water enters inside
the Movie Camera.
≥Water may cause the Movie Camera or Cassette to
malfunction. (Irreparable failure may occur.)
≥If sea water splashes onto the Movie Camera, wet a soft
cloth with tap water, wring it well, and use it to wipe the
camera body carefully. Then, wipe it again thoroughly with
a soft dry cloth.
Keep the Movie Camera away from magnetized
equipment (such as a microwave oven, TV, video game
equipment, etc.).
≥If you use the Movie Camera on or near a TV, images or
sounds may be disturbed due to electromagnetic wave
radiation.
≥Do not use near a cell phone because doing so may cause
noise to adversely affect the picture and sound.
≥By strong magnetic fields created by speakers or large
motors, recording on the tape may be damaged, or images
may be distorted.
≥Electromagnetic wave radiation generated by a
microprocessor may adversely affect the Movie Camera,
causing the disturbance of images and sounds.
≥If the Movie Camera is affected by magnetically charged
equipment and does not function properly, turn off the
Movie Camera power and detach the Battery or AC
Adaptor and then connect the Battery or AC Adaptor again.
Thereafter, turn on the Movie Camera power.
Do not use your Movie Camera near radio transmitters
or high-voltage lines.
≥If you record pictures near radio transmitters or
high-voltage lines, recorded images or sounds may be
adversely affected.
Do not use this Movie Camera for surveillance purpose
or other business use.
≥If you use the Movie Camera for a long period of time, the
internal temperature increases and, consequently, this may
cause malfunction.
≥This Movie Camera is not intended for business use.
When you use your Movie Camera on a beach or similar
place, do not let sand or fine dust get into the Movie
Camera.
≥Sand or dust may damage the Movie Camera or Cassette.
(Care should be taken when inserting and removing the
Cassette.)
56
(l 10)
l
( 9, 11)
Do not spray insecticides or volatile chemicals onto the
Movie Camera.
≥If the Movie Camera is sprayed with such chemicals, the
camera body may be deformed and the surface finish may
peel off.
≥Do not keep rubber or plastic product in contact with the
Movie Camera for a long period of time.
Do not use benzine, thinner or alcohol for cleaning the
Movie Camera.
≥The camera body may be deformed and the surface finish
may peel off.
≥Before cleaning, detach the Battery or pull out the AC
Mains Lead from the AC mains socket.
≥Wipe the Movie Camera with a soft dry cloth. To remove
stubborn stains, wipe with a cloth that is soaked in a
detergent diluted with water and afterward finish wiping
with a dry cloth.
≥For storing or transporting the Movie Camera, place it in a
bag or case lined with soft pads so as to prevent the
coating on the camera body from being worn.
After use, be sure to take the Cassette out and detach
the Battery from the Movie Camera or pull out the AC
Mains Lead from AC mains socket.
≥If the Cassette is left in the Movie Camera, the tape sags
and deteriorates.
≥If the Battery is left on the Movie Camera for a long time,
the voltage drops excessively, and the Battery will not
function even after it is recharged.
ª About AC Adaptor
≥When the Battery is attached or removed during charging,
the [CHARGE] Lamps may temporarily fail to show the
correct display or they may go off for a moment because
the charge is being measured: this is normal and not a
malfunction.
≥When the Battery is re-attached while the [QUICK] Lamp is
lighted and the [100%] Lamp is flashing, the [QUICK] Lamp
starts flashing again, and it may take some moments for
the lamp to stop flashing and light: this is normal and not a
malfunction.
≥If the Battery is warm, charging takes a longer time than
normal.
≥If you use the AC Adaptor near a radio, radio reception
may be disturbed. Keep the AC Adaptor 1 metre or more
away from radio.
≥When the AC Adaptor is in use, it may generate whirring
sounds. However, this is normal.
≥After use, be sure to pull out the AC Mains Lead from the
AC mains socket. (If they are left connected, a minute
amount of current is consumed.)
≥Keep the electrodes of the AC Adaptor and Battery always
clean.
When the Charge Lamps on the AC Adaptor Flash
as Warning
When the Charge Lamps Flash Slowly
The temperature of the Battery is low (or high), or the Battery
is excessively discharged, therefore, charging takes longer
than normally.
When the [QUICK] and [100%] Charge Lamps Flash
Alternately, or When No Charge Lamps Light
Remove and then re-attach the Battery. Or, attach the
Battery to the Movie Camera and perform playback (or some
other operation) for 10–20 minutes. Then remove the Battery
and attach it again to the AC Adaptor. If charging is still
impossible, some malfunction has occurred in the Battery or
the AC Adaptor. Please consult with your dealer.