Samsung NS Series User & Installation Manual page 32

Setting an indoor unit address and installation option
Setting an indoor unit installation option
In order to check and set the indoor unit installation option code use the wired remote controller and follow the directions
below.
1. Press the and
2. Press the / button to select
3. Press the / button to select
screen.
• The first digit represents the page number and the remaining five digits are installation option.
• The total option codes are 24 digits. You can set six digits at a time and it is distinguished by page number
NOTE
(0, 1, 2, 3).
4. Press the / button to set the installation option code in order. Press
SGE1 SGE2
0 2
SEG7 SEG8
1 Drain pump
SEG13 SEG14
2 External control
SEG19 SEG20
Individual control of a
3
remote controller
32
buttons at the same time for more than 3 seconds and then a Main menu will be displayed.
and then press
and then press
SGE3
RESERVED
SEG9
RESERVED
SEG15
External control
output
SEG21
Heating setting
compensation
button to enter a Sub-menu setting screen.
button to enter a Indoor unit installation option code setting
button to go to the next page.
SGE4
Exterior temperature
Central control
sensor
SEG10
RESERVED
SEG16
S-Plasma ion
-
-
SGE5 SGE6
RESERVED
SEG11 SEG12
RESERVED Master / Slave
SEG17 SEG18
Number of hours
Buzzer
using filter
-
-
-
-