Using The Control Panel - Samsung Refrigerator User Manual

operating your samsung
refrigerator

USING THE CONTROl PANEl

1
2
3
10
( 1 )
Press the Energy Saver button for better
energy efficiency.
Energy
The Energy Saver icon lights up when you
Saver
press the Energy Saver button.
The Energy Saver function is automatically
set to "ON" when power is supplied to the
refrigerator.
If condensation or water drops appear on
the doors, turn the Energy Saver mode off.
( 2 )
The Power Freeze function substantially
speeds up the freezer compressor,
Power
causing the freezer to cool down rapidly
Freeze
to a temperature you choose. When you
press the Power Freeze button, the Power
Freeze icon lights up.
Power Freeze is useful if you need to quick
freeze an item, to make a large quantity of
ice, or to cool the freezer rapidly if it has
warmed dramatically (for example, if the
door was left open).
To turn off Power Freeze, press the Power
Freeze button again. Power Freeze turns
off automatically after 72hours to decrease
energy consumption.
When you use this function the energy
consumption of the refrigerator will
increase. Remember to turn it off when you
don't need it and return the freezer to your
original temperature setting.If you need to
freeze large amount of food stuff, set the
temperature of freezer compartment as
the coldest
temperature before you turn on the Power
Freeze Button.
12_ operating
9
7 8
( 3 )
Alarm /
hold 3
sec for
4
Filter
Reset
5
6
(Filter Reset)
( 4 )
Lighting
The Alarm/Hold 3 sec for Filter Reset
button serves two purposes:
- To turn the door open alarm on and off
- To reset the water filter life indicator.
1) Door Alarm Function
If the door alarm is set to On, an alarm
beeps if any refrigerator door is left open
for more than three minutes.
The beeping stops when you close the
door. The door alarm function is pre-set
to On in the factory. You can turn it off by
pressing and then releasing the Alarm/
Hold button. You can turn it back on in the
same fashion. The icon lights up when the
function is on.
2) Water Filter Life Indicator Function
After you replace the water filter, press and
hold the Alarm/Hold 3 sec for Filter Reset
button to re-set the water filter life indicator.
The Filter icon will turn red to let you know
it is time to change the water filter after six
months (about 1135 L).
Some areas have large amounts
of lime in their water, which causes
the water filter to clog more quickly.
If this is the case in your area, you
will have to change the filter more
frequently than every six months.
Pressing the Lighting button turns on the
Dispenser LED lamp (under the display)
in continuous mode so that it stays on
continuously. The button also lights up. If
you want the Dispenser lamp to come on
only when some one uses the dispenser,
press the Lighting button to turn the
continuous mode off.