Samsung Refrigerator User Manual page 10

Fixed
1. If you open the drawer ( 1 ), you can see the
lower hinge ( 2 ) .
2. Insert the supplied hex wrench ( 3 ) into the shaft
( 4 ) of the lower hinge.
3. Please adjust the height by turning the hex
wrench ( 3 ) clockwise (
clockwise ( ).
When you turn the hex wrench counter-
clockwise(
1. After adjusting the doors, please insert the
supplied fastener-ring ( 5 ) using a pair of pliers
( 6 ) in the gap between the hinge-grommet ( 7 )
and the lower hinge ( 8 ). The number of fastener-
rings you'll need to insert depends on the gap.
Two fastener-rings are enclosed with the
refrigerator.
The thickness of each fastener-ring is 1mm.
AdJUSTING THE FREEZER
dRAWER lEvEl
Adjustment part
10_ setting up
Adjustment
part
Part
) or counter-
2
3
4
1
), the door will move up.
Freezer drawer
1. Locate the height-adjuster ( 1 ) in the freezer
drawer.
Unscrew the four Phillips screws ( 2 ) slightly to
loosen the door.
2. Loosen the controller screw ( 3 ) with a Phillips
screwdriver.
3
3. Find the best level to align the door slope.
Example) The slope is about 2mm (0.08inch) as shown below.
- Rotate the Height Adjuster to -2.0 to reduce the door slope.
Slope
Reference
plane
After adjustment, first tighten screw ( 3 ) and
then screw ( 2 ) .
CHECKING THE WATER lINE
A water dispenser is one of the helpful features on
your new Samsung Refrigerator. To help promote
better health, the Samsung water filter removes
unwanted particles from your water.
1 2