Connecting; Installing; To Install On A Wall Surface (Concrete And Solid Wall) - Samsung SNC-L200 User Manual

2. Connecting

2.1 Connecting
➀
Push downward and remove the cover located at the back of Netcam.
➁
Connect one end of the Ethernet cable to the router.
➂
Connect the other end of the Ethernet cable to the back of Netcam.
➃
Connect the power adapter and power cable to the power outlet and then connect
them to the back of Netcam.
➄
After the power is connected for 1 minute, make sure Netcam lens automatically
moves.
➅
Close the cover at the back of Netcam.

2.2 Installing

Install directly on the wall or on let it stand on a flat surface as a tabletop type.
You may install it where you want by using separate stands, such as wall mount.
(However, when using supplementary stands such as a wall mount to install, make sure the
stand can be secured to the nuts on the back of the SET.
Precautions while installing Netcam
*
- When installing on the wall, make sure the location can withstand more than the SET
weight (app. I kg).
- There is a falling hazard after the SET is installed on the wall. Make sure nobody comes
close to it.
- The SET is intended or indoor use. Install it in a place where it cannot be reached by
rain, water, or with less humidity.
- When installing using a fixed type stand and separate structures, make sure to secure
them so they do not become loose from the nuts on the back of the SET.
Video Netcam | SNC-L200
10
2.2.1. To install on a wall surface (concrete and
solid wall)
1. Drill two holes (Diameter: 5 mm, Depth: 35 mm) on the installation location using an
electric driller. Vertical distance between the two holes should be 35 mm.
* It would be convenient for you to stick the enclosed label template on the
installation surface and use it.
2. Insert the enclosed two plastic anchors to the holes (one each) and tighten the
screws with a driver.
* To install on a regular wooden wall, refer to the figure above and tighten two screws
with a driver.
3. Remove the cover from the back of the SET. Plug in LAN-CABLE and POWER
CORD. Align the two to the groove of the cover, and then close the cover as shown
in the figure below.
4. Align two grooves at the back of the SET to the pre-installed screws on the wall
and hang the SET. Pull it slightly downward. The installation is complete.
Video Netcam | SNC-L200
Connecting
Ø5mm 2 Hole
11