Setup; Registration - Samsung SNC-L200 User Manual

10.

Setup

Refer to "6.5 Setup."
11. Disconnect
It closes the image channel that has screen selection cursor. Steps are as follows:
1) Select the image you want to close among the images being displayed.
2) Press "Disconnect" icon. The following message appears.
3) Click "Yes" to close the image of the channel that has screen selection cursor. Then
the images behind the blank window will be pushed upward one frame at a time.
4) In addition to the channel selected, the channel images that cannot communicate with
Netcam will also be closed.
5) Click "No" to cancel closing the image of the channel that has screen selection cursor.
12. Subtitle Show/Hide
It turns the window in which the image information such as time or server name that is
displayed on the screen window as text On/Off.
1) If you press the "Subtitle Show/Hide" icon, Netcam information will be displayed at the
bottom of each screen as below.
2) If you want to hide the subtitle display, click the "Subtitle Show/Hide" icon one more
time.
13. Record
1) Select the image you want to record among the images being displayed from the
screen window.
2) Pressing the "REC" icon will start recording while "REF-F" is displayed on the OSD
window.
3) Likewise, to record another image, select that image and then press "REC" icon. The
recording will start.
- When using the default folder as the recording folder, the path is as follows:
{install drive}:\Program Files\Network Camera MultiViewer\Video Files
- Recording time continues by creating a 10-minute file per IP after recording is started.
- Recording stops when the hard disk capacity is below 5 GB.
4) To stop recording, select the channel you want to stop recording, and press "REC"
icon one more time.
** Recording stops automatically when the hard disk capacity is below 5 GB. Check the
hard disk capacity before recording if you want to record continuously.
When Alarm occurs, that window will flash while recording is not happening.
Video Netcam | SNC-L200
Netcam MultiViewer
54
14. Print
Prints the selected Netcam video.
The Video at the time "Print" is clicked will be printed.
Refer to 6.6 Print.
15. Capture
Use it to save a still video from live videos to a JPEG file.
To capture:
1) Select the video you want to capture from the screen window where videos are
displayed.
2) Click "Capture" icon. The path and numbers of pictures saved will be the folder
and frame number settings for Image Capture in the Viewer Setup.
16. Motion
Sets up the motion detection mode of the Netcam selected.
Refer to 6.7 Motion.
17. Flash
Enables the Flash On/Off function in the currently selected channel.
When Flash On is selected, it flashes for 5 seconds then is off for 30 seconds.
During this Flash Off mode Flash On is disabled.
18. PIR
Enables the PIR Sensor On/Off function in the currently selected channel.
It flashes for 5 seconds automatically when there is a movement on the PIR
sensor of the relevant camera, and recording takes place for 5 seconds with
'REC-A' showing in red.
6.5 Setup

6.5.1 Registration

Connects the Netcam installed in the LAN or WAN network to the MultiViewer.
Click Setup ( ) icon. The following window appears.
Video Netcam | SNC-L200
Netcam MultiViewer
55