Siemens Gigaset C350 Manual page 20

Opening lists with
the message key
You can use the message key f to open
the following lists:
u
SMS list
u
Network mailbox
If your network provider supports this
function and the network mailbox is
specified for fast access (page 26).
u
Caller list
An advisory tone sounds as soon as a new
message arrives on a list. The message
key f flashes. In idle status, an icon
appears in the display for the new mes-
sage:
Icon New message...
±
... in network mailbox
Á
... in calls list
À
... in SMS list
The number of new entries is shown
beneath the corresponding icon.
When you press the flashing key f, you
will see all the lists that contain new mes-
sages. If only one list contains new mes-
sages, it opens immediately.
Key f goes out when a list opens and the
menu is closed. If there are other new
entries, you can set the message key flash-
ing again (page 17), e.g. to tell other
users about the new entries.
Note:
If calls are stored in the network mailbox you
will receive a message if the appropriate set-
tings have been made (see the network mail-
box instructions of your network provider).
Setting the message key flashing
Requirement: There is still at least one
new entry in one of the lists.
f
Open the calls list.
Select Set MWI-LED
press
§OK§
a
Press and hold (idle status).
and
.
Using the directory and lists
Key f goes out when a list opens and the
menu is closed.
Calls list
Requirement: CLIP (page 11)
The numbers of the last 30 incoming calls
are stored. Depending on the
tings either All Calls or only
stored (page 17).
Several calls from the same number are
stored depending on the type of list:
u
stored more than once.
All Calls
u
stored once (the last call).
Missed Calls
The calls list is displayed as follows:
Calls List: 01+02
Number of new entries + number of old, read
entries
Setting the list type for the calls list
¢
f
Calls List: 01+02
¢
q (select entry; page 14)
¢ ¢
Calls List Settings
§Menu§
Select Missed Calls
and press
a
Press and hold (idle status).
The entries in the calls list are retained
when you change the list type.
Calls List Set-
Missed Calls are
/ All Calls
(‰ = on).
§OK§
17